Re: USERENV Events 1030/1058 Access Denied to GPT.ini

Ok,
Security Settings are Applied, when a computer is restarted, Every 90
minutes on a workstation or server and every 5 minutes on a domain
controller.
So what is happening is that the DC is trying to refresh the GPO but can't
because of that access error. You already did all commun steps to try to
solve that, and according with your results everything should be fine, but
that's not the case, so you may want to try some alternetives.
Another thing that we don't checked yet is the clock, did you check if the
clock is synced with all other DCs (check that is important to have the
clock sync)?
For what policy or policies are you getting this error? I'm asking this
because you may also try to delete that policy that is giving you that error
and rebuild a new one, but DON'T do that now, I think that would be better
to try the all other options before and at the end if nothing solves that,
you may want to think about rebuilt a new one, of course you should analyze
what policie is giving youproblems, do backup, replicate changes and them
rebuild a new one.

Let me know what do you think.

--

I hope that the information above helps you.
Have a Nice day.

Jorge Silva
MCSE, MVP Directory Services

<getkevin@xxxxxxxxx> wrote in message
news:1191505990.808830.264670@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I will try to dissolve the team this week. The DC's are at a remote
site so I will have to travel to get there. The Event logs are clean
of errors. Just standard informational entries. In regards to the
1030/1058 errors, they are not always every 5 minutes. sometimes
there will only be a couple entries in an hour. What is happening to
the domain controller that prompts it to display those errors and in 5
minute increments?


On Oct 4, 9:37 am, "Jorge Silva" <jorgesilva...@xxxxxxxxxxx> wrote:
When I say errors, I mean other than 1030/1058





.

Relevant Pages

  • Re: Generating 6MHz output frequency
    ... using an EPSON controller ... As I have to use STR9 chip, I'm trying to figure out if I can really obtain this output frequency: the problem is that the micro PLL can raise the internal clock frequency upto 96MHz. ... At first look, I might have to invoke a sort of IRQ @ 12MHz to drive the output pin HIGH-LOW with 50% duty-cycle: may I use a timer output compare interrupt, but here comes the trouble. ...
    (comp.arch.embedded)
  • Re: atacontrol Raid, cannot re-add member to array
    ... I have tried the detach/attach on a non-raid controller to simulate ... failure and have *never* managed to get rebuild to work. ... I've never had any hotswap-capable drives to test the hot-swap ...
    (freebsd-stable)
  • Re: 3Ware-8006-2: extrem langsamer Rebuild
    ... wenn die Platten keine dolle Zugriffszeit haben. ... der Controller wirlich so langsam beim Rebuild? ... Normalerweise ist der Trick erst Rebuild und dann Server nutzen. ...
    (de.comp.hardware.misc)
  • Re: 3Ware-8006-2: extrem langsamer Rebuild
    ... Die Prioritaet des Rebuild laesst sich ueber das 3DM-Tool einstellen. ... unit 8 on controller ID:6. ... Willst Du gegen identischen Kontroller tauschen: ...
    (de.comp.hardware.misc)
  • Generating 6MHz output frequency
    ... I need to drive a 320x240x8bbp TFT color display. ... using an EPSON controller ... As I have to use STR9 chip, I'm trying to figure out if I can really obtain this output frequency: the problem is that the micro PLL can raise the internal clock frequency upto 96MHz. ...
    (comp.arch.embedded)