Re: DMA2200 Extender connection problem

I have a cabled network, and they are connected via a router with built in
switch.
Funny, now I cannot see it at all...

--
Best regards,

Nikolaj Johansen
Windows XP MCE 2005 SP2
WMP: 10.00.00.3802
PowerDVD6 Deluxe
---> WLAN 802.11a --> XBOX 360


"Barb Bowman" wrote:

sounds like it can't find the media center pc. is that the message
you see? how are you connecting this device to your network?

On Sat, 9 Feb 2008 00:39:01 -0800, Nikolaj
<Nikolaj@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote:

Can configure the DMA2200 without problems (well, might have to re-start the
setup a couple of times to detect the extender, but in the end it succeeds).
However, everytime I have put the DMA2200 into standby, it restarts the
media center setup process (setup key etc.), when I turn it back on, and I
have to do everything all over.

I have a XBOX 360 as well, and it jumps right back on Vista Media Center,
when switched on.

Any suggestions?
--

Barb Bowman
MS-MVP
http://www.microsoft.com/windowsxp/expertzone/meetexperts/bowman.mspx
http://blogs.digitalmediaphile.com/barb/

.

Relevant Pages

  • Re: Anyone successfully bonding 2 ether ports?
    ... I am a bit rusty on this, but if you setup the box with 2 ports configured with one IP address your connected layer 2 switch also needs some intelligence to know that you are running it this way. ... From memory Cisco's CDP use to get into trouble and had to be disbled if you setup a "loop" between two of their devices (eg connecting two L2 switches with two cables) in this way. ...
    (alt.os.linux.suse)
  • Re: RIS running slowly
    ... We created a second IP address on the network card of the RIS server and it ... Once it gets past the early part of the setup, ... > that has changed since we moved it is perhaps the port on the switch into ... > The switches involved are Cisco Catalyst 3500 and I have tried connecting ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: Electrical Questions
    ... It's fairly a common way to power a switch. ... travelers to a load you would have connected them to each other and the ... How can one connect something to each traveler without connecting to ... So Switch-1 controls whether one side of the lamp is hot ...
    (alt.home.repair)
  • Re: LAN + shared Internet connection
    ... Gigabit Ethernet Switch? ... and simply run a cable from a LAN port on the router to a LAN port on the ... I am aware that it is possible to set up his office computer to use ... some problems getting the computers on the LAN connecting to each other. ...
    (microsoft.public.win2000.networking)
  • Re: Electrical Questions
    ... It's fairly a common way to power a switch. ... travelers to a load you would have connected them to each other and the ... How can one connect something to each traveler without connecting to ... So Switch-1 controls whether one side of the lamp is hot ...
    (alt.home.repair)