When I right click my dvd/cd drive in my computer in order to format a CD-RW
disk, I receive the message "file lgc.bin is not present in the working
directory or was damaged".
I have only tried system restore without success. Any advice gratefully
received.
Re: storage question ... > I agree with Slobodan that USB disks with wear leveling algorithms in the firmware is a an option for you. ... > Some other IDE Flash Disk may also be a good option to you. ... >> Regards,... there is data (refreshed from time to time over the network) should be available after an event where the target is ... (microsoft.public.windowsxp.embedded)
Re: Data Transfer: Computer Win2000 to Computer WinXP ...Regards,...Dave Patrick ....Please no email replies - reply in newsgroup. ... | since it's a nightmare trying to simply transfer data between PCs. ... I just needed to load the new disk into ... (microsoft.public.win2000.file_system)
Re: drive speed ...Regards,... Is the drive set to run in Ultra DMA or DMA mode or in POI ... > disk the same thing may/will occur. ... > Richard Urban... (microsoft.public.windowsxp.general)
Re: Windows xp service pack 2 ... I recently reformated my main computer and finished updating all my drivers, installing most of my software and runing various windows updates.... I have read the articles on how to remove the uncomplete install of service back 2 but they all involve the disk.... (microsoft.public.windows.mediacenter)
Re: Get current working directory ... the working directory is what i searched. ... Best regards,...support....windows folder and start it from a telnet session from another folder ... (microsoft.public.windowsce.embedded)
