Re: Media Center 2005 installation woes

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

You know, now that I think about it, I did make changes to the boot
sequence. But I believe at the time there were only two choices: boot
from cd or boot from floppy. I'll see what I can come up with and I
will give that a try later tonight and see what happens. And yes, after
the initial problems I did start from scratch.
I'll post back here later tonight with my results.


On Nov 2, 8:01 am, "Jaime" <jaimel...@xxxxxxxxxxx> wrote:
Is it possible that your system is set to only boot from the CD? It sounds
like after restarting, the system is booting from the CD and starting the
install process.

Normally, a prompt comes up "Press a key to boot from CD" (or something to
that effect), if you don't, the system drops to the next device (hard drive)
and boots from there. You could try removing the CD during the reboot and
see what happens.

Also, when you had the initial problems, did you start from scratch and do a
clean install?
--
James
Orlando (Goofy says "Hey!"), Florida

<dbridge...@xxxxxxxxx> wrote in messagenews:1162447022.540721.12910@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

Installing Media Center 2005 OEM. Setup went fine until the whole
"insert SP2" screen. Canceled it. Didn't work. Tried installing it
again with the new given knowledge to reinsert the first disk, and the
installation goes fine until it gets done copying the files and
reboots. Then it just starts the entire process over again. Any
suggestions before I take a hammer to the hard drive?

.

Relevant Pages

  • Re: OEM version of xp from 98se
    ... if I go to reboot (which I assume ... setup to change boot on floppy to boot on cd, ... >To Repair a Windows XP Installation using Recovery ... >>I have an oem version of xp to install. ...
    (microsoft.public.windowsxp.basics)
  • Re: New XP system hangs after OSloader screen
    ... boot normally, which is the only way I could apply this bios update (can't ... install it in safe mode). ... After installing the last driver, you must reboot, so I restared the ... I have rebooted in safe mode and done system restore points back to before I ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: Scientific Calculators
    ... Well, you could say "you can use any laptop, as long as it can boot this ... Install the ... they *could* reboot back to their ... access to his real system. ...
    (rec.arts.sf.written)
  • Re: New XP box will only boot in safe mode?
    ... I too can reboot this PC and during the boot up process I see the post. ... to install a symantec upgrade at http://tinyurl.com/yckf2z. ... You can access Event Viewer by selecting Start, ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: XP HOME BOOT FAILURE
    ... Boot the system, start tapping F8, when the menu appears, select ... download install and run the application: ... A repair install should bypass that but it will ... >> on, follow the screens. ...
    (microsoft.public.windowsxp.accessibility)