Re: Audio missing fron some recorded programmes
- From: "Jason Tsang" <jason-onlineDEL@xxxxxxxxxxx>
- Date: Fri, 24 Feb 2006 14:34:10 -0500
Looks like a new driver set was released today.
See here for info
http://www.hauppauge.co.uk/board/showthread.php?t=6944
--
Jason Tsang - Microsoft MVP
Find out about the MS MVP Program -
http://mvp.support.microsoft.com/default.aspx
"TimDavey" <TimDavey@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:5E9D530B-647F-48B4-87C2-0043C8FEF54F@xxxxxxxxxxxxxxxx
Hi
I have just purchased an Elonex Artisan LX. The two tuners are Hauppauge
Hybrid WinTV Nova-T. I am using a standard aerial and a powered
amplifier/splitter. The signal quality is good - picture is perfect and
most
recordings are fine. But about 1 in every 10 recordings have no audio.
None
at all from beginning to end. All other recordings are fine. I have copied
a
faulty recording to my desktop PC and there is no audio there either when
played with media player, so it looks as if the tuner card is not writing
any
audio into the MPEG stream. Elonex are stumped - they have updated the
drivers to the latest on the Hauppage site, and have replaced both tuner
cards. They say they have never seen this before, and a search of the
forums
both here and on Micro$oft suggests no-one else has either! I am only
trying
to hear standard stereo audio on the line out phonos, not anything more
challenging.
Anyone got any ideas where I go from here? Is the MPEG data generated
entirely on the tuner card so the audio must go missing that early in the
recording? Or could MCE be losing it afterwards? This fault occurs even if
only only one of the Tuners is in use.
Hope someone can help...
Tim
.
- Prev by Date: Re: Does Divx work with Media center 2005
- Next by Date: Re: Multiple Tuner, Analog cable and STB
- Previous by thread: Re: MCE 2005 vs. MCE 2004
- Next by thread: Re: Audio missing fron some recorded programmes
- Index(es):
Relevant Pages
|
