Re: Scrolling problem on some sites

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

PA Bear [MS MVP] wrote:
The bulk of the Add-ons which load in each and every IE window and tab (in IE7) do NOT load in SeaMonkey and most other browsers.

[When you refer to OE, I suspect you meant to refer to IE...unless you might have configured OE to run in the Internet zone. By default, OE runs in Restricted Sites zone and I would strongly advise that you keep it that way!]

Yes, I did mean IE, not OE. Is there a way of controlling which add-ons load in each IE window?

Thanks,

Ray
.

Relevant Pages

  • RE: help
    ... Pls clear the CMOS and load setup default, then set the correct time in CMOS. ... >> You can refer this to the downloaded user manual. ...
    (microsoft.public.windowsxp.hardware)
  • RE: LNK2005 error
    ... Please refer to the following MSDN documentation: ... the "Failed to load" error may be caused by the IIS ... cannot find those shared MFC dlls. ...
    (microsoft.public.vc.ide_general)
  • Elements of an Array in For Loop
    ... How do you refer to the elements of an array that you load in a for loop? ... for the subplot section how can the variable be set so that it changes every time from X1 to X2 and so on until the loop gets over. ...
    (comp.soft-sys.matlab)
  • Elements of an Array in For Loop
    ... How do you refer to the elements of an array that you load in a for loop? ... for the subplot section how can the variable be set so that it changes every time from X1 to X2 and so on until the loop gets over. ...
    (comp.soft-sys.matlab)
  • Re: Elements of an Array in For Loop
    ... How do you refer to the elements of an array that you load in a for loop? ... for the subplot section how can the variable be set so that it changes every time from X1 to X2 and so on until the loop gets over. ...
    (comp.soft-sys.matlab)