Re: VPN Endpoint tunnel connected but can't connect to RD
- From: Sooner Al <SoonerAl@xxxxxxxxxxxxxxxxxxxxx>
- Date: Wed, 04 Jan 2006 18:53:54 -0600
Reply to message from Jake <Jaker00at@xxxxxxxxx> (Wed, 04 Jan 2006 17:29:36) about "VPN
Endpoint tunnel connected but can't connect to RD":
> Hello,
> I've been struggling with a problem that I hope someone can help with.
> I've got two Linksys VPN routers (BEFSX41 ~ BEFVP41) that I have established a tunnel
> between over the internet.. The tunnel is connected and stays connected so that's
> apparently not the problem.
> I am trying to reach a Windows XP Pro machine behind BEFVP41 from another Windows XP
> Pro machine behind BEFSX41. I am getting the dreaded "REMOTE DESKTOP DISCONNECTED" -
> "The specified remote computer could not be found".
> I've configured the tunnel to pass NetBIOS traffic on both ends.
> I've tried entering the IP address of the destination machine in the RD client
> connection dialog.
> I can connect to the destination machine from another XP Pro machine that's on the same
> LAN using the machine name.. So the RD configuration is ok.
> The destination site has DSL and the modem (Speedstream 5660) is in bridge mode so that
> the BEFVP41 is getting the WAN IP from the ISP. Everything else works ok.
> I have this same setup working fine with another configuration so I'm stumped about
> what else to look at.
> Any ideas ?
> Thanks
> Bryan
Can you ping the PC by using its IP?
Also make sure the two sub-nets are different, ie. one 192.168.1.X versus 192.168.2.X for
example...
------
Al Jarvi (MS-MVP Windows Networking)
=== Posted with Qusnetsoft NewsReader 3.3 for the PocketPC
.
- Follow-Ups:
- References:
- Prev by Date: Re: Help setting up remote connection over internet
- Next by Date: Re: Cut & Paste problem with RDP
- Previous by thread: VPN Endpoint tunnel connected but can't connect to RD
- Next by thread: Re: VPN Endpoint tunnel connected but can't connect to RD
- Index(es):
Relevant Pages
|
