Re: Remote Desktop Immediately disconnecting

From: Jeffrey Randow (MVP) (jeffreyr-support_at_remotenetworktechnology.com)
Date: 04/19/04


Date: Mon, 19 Apr 2004 18:47:29 -0500

That I can't tell you (I use ATI cards)... The issue was with that
particular service included with the newer display drivers...

Jeffrey Randow (Windows Net. & Smart Display MVP)
jeffreyr-support@remotenetworktechnology.com

Please post all responses to the newsgroups for the benefit
of all USENET users. Messages sent via email may or may not
be answered depending on time availability....

Remote Networking Technology Support Site -
http://www.remotenetworktechnology.com
Windows XP Expert Zone - http://www.microsoft.com/windowsxp/expertzone

On Sun, 18 Apr 2004 22:46:02 -0700, Cosette Sunrise
<anonymous@discussions.microsoft.com> wrote:

>NVIDIA Display Driver Service is started. But if I disabled it, will my graphic card have the same performence? Or it will act as if the nvidia driver's not installed?
>
>Thanks.



Relevant Pages

  • RomFS: enless loop during make oldconfig from 2.6.24 -> 2.6.31-rc4 (parisc)
    ... # IPVS transport protocol load balancing support ... # DCCP Kernel Hacking ... # Device Drivers ... # Display device support ...
    (Linux-Kernel)
  • [regression] drm: display arifacts when X.Org is stopped
    ... With 2.6.31-rc1 I'm getting fairly serious display artifacts when X.Org ... HP 2510p notebook with Intel Core Duo processors; x86_64 kernel ... # CPUFreq processor drivers ... # Device Drivers ...
    (Linux-Kernel)
  • Re: [PATCH 01/01] x86: L3 cache index disable for 2.6.26
    ... display which caches indices are disabled and to monitoring ... This patch does not set an automatic policy to disable the L3 cache. ... # Infrared-port device drivers ...
    (Linux-Kernel)
  • Re: Blank screen after installing Graphics Drivers
    ... Sytem boots into safe mode okay with display and also vga mode okay with ... Remove the drivers and the system will boot normally into windows ... I have tried both DVI and VGA cable to rule out resolution and refresh ... monitor can't use. ...
    (microsoft.public.windows.vista.hardware_devices)
  • Re: Blank screen after installing Graphics Drivers
    ... Sytem boots into safe mode okay with display and also vga mode okay with ... Remove the drivers and the system will boot normally into windows ... I have tried both DVI and VGA cable to rule out resolution and refresh ... monitor can't use. ...
    (microsoft.public.windows.vista.hardware_devices)