hi, i m working on dotnet using wmi and making an application to monitor the add
or remove of the hardware. to monitor any device serial no is the unique
identifier of the device i successfully get the serial number of motherboard
and harddisk but unable to get serial number of monitor , cd rom and ram
kindly help me in this regard
Re: PC wont restart if shut down for more than approx 5 minutes ...restart after 5 minutes, it is a weak power supply or bad ... bad power supply in the monitor,... Have you added any new drives or video cards? ... | general hardware troubleshooting steps. ... (microsoft.public.windowsxp.hardware)
Re: PC Problem on boot up ...monitor stays blank except a small cursor in the upper left. ... has not successfully gone through the boot routine.... from the motherboard, the power supply or somewhere else. ...Hardware failures just happen. ... (comp.os.linux.setup)
Re: TRS80 Model IV video to TV? ... sunk/sync'ed up without any extra hardware.... If someone did get an LCD Multisync Monitor to work on a Model 3 or 4 ... again TRS-80 you could probably instead pick up an old 100Mhz Pentium ... based TRS-80 emulator...... (comp.sys.tandy)
Re: TRS80 Model IV video to TV? ... sunk/sync'ed up without any extra hardware.... If someone did get an LCD Multisync Monitor to work on a Model 3 or 4 ... again TRS-80 you could probably instead pick up an old 100Mhz Pentium ... TV's scart plug and do it with the separate signals but they would have ... (comp.sys.tandy)
