Ok, my nVidia GeForce 440 PCI 64Mb is shot. But the BIOS is set to read
that
card for the display. So, when I turn the computer on, the monitor stays
blank, but there is no "check cable" message. How can I reset the BIOS
settings to defaults so I can plug the monitor cable into the integrated
intel video card and get some video feedback? Help is greatly
appreciated!
One way is to clear the CMOS. There will be a jumper on the motherboard
that can be set to clear the CMOS - you will need your MB manual to identify
which jumper. This then sets the CMOS to default settings.
Re: What is this Amdek card?? ... doesn't have the 10 pin header, only the 16 pin header, and only two ... header on my card....monitor I needed to regenerate a vsync and to invert the sync signalshttp://home.online.no/~kr-lund/A2E-CGA.htm). ... cards) the red jumper came off and no one knew where to put it. ... (comp.sys.apple2)
Re: What is this Amdek card?? ... doesn't have the 10 pin header, only the 16 pin header, and only two ... header on my card....monitor I needed to regenerate a vsync and to invert the sync signalshttp://home.online.no/~kr-lund/A2E-CGA.htm). ... cards) the red jumper came off and no one knew where to put it. ... (comp.sys.apple2)
Re: Dead PC - Wont POST ... disconnected everything except the monitor and the ... Next step is to clear the CMOS.... Take the battery out and short the ... If there is a "clear CMOS" jumper,... (uk.comp.homebuilt)
Re: redhat vs debian ... I think maybe in terms of video games Linux is week, ... I have UT 2003 and did successfully install it on my RH linux box. ... Finally I switched back the original video card and rebooted. ...monitor and the gforce card. ... (linux.redhat)
Re: Multiple Video Cards and Monitors - Dapper ... I've been trying to get a multiple monitor/video card setup working...Load "bitmap"...Identifier "Generic Keyboard" ... Identifier "NEC Monitor"... (Ubuntu)
