Re: Setup crashes before drive selection

Stop code 7B indicates a boot device failure. This boot device could
include one of the following components: a disk drive, an Integrated Drive
Electronics (IDE) controller, a primary IDE channel, a secondary IDE
channel, a PCI bus, or another boot device.

Make sure all these devices are enabled in the BIOS.

Dean

"EWake42" <EWake42@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:D3C89D47-5169-4000-A6A6-19AE952CBE6B@xxxxxxxxxxxxxxxx
I was wondering if you ever resolved this problem. I have exactly the
same
set-up, same mother boardd, etc, and am having the same problem. Any nfo
would be appreciated.
--
EWake42


"nt82777" wrote:

I have recently built a new computer with an asus P5WD2 Premium
motherboard.
I have installed 2 512mb ram chips that are ddr2 800 (ddr2 is native on
this
board).

I have attemtped using both an SP1 XP pro disk, and an SP2 xp pro disk,
and
I get the same results.

I press a key as directed to begin booting setup from the cd. Setup
loads
its necessary files, the last thing being NTFS, and then it says 'setup
is
starting windows'.
At this time, the screen goes blank for about 3 seconds, and a blue
screen
comes up with a stop message:

*** STOP: 0x0000007B (0xf7c7a524, 0xc0000034, 0x00000000, 0x00000000)

I am uncertain what to do at this point because I am completely unable
to
even begin an install, let alone complete one.


.

Relevant Pages

  • Re: Figured it out: IDE controller had reverted to PIO mode
    ... HP put a 40wire ide cable in mine instead of an 80wire one going to my DVDRW ... IDE (I have a USB enclosure for the disk). ... reader driver to handle 2GB cards. ... I ran the disk diagnotics from Windows, ...
    (comp.sys.hp.hardware)
  • Re: Alleged IDE to SCSI adapter - Advice sought from you folks!
    ... 50-pin centronics out on one side of the board, and a male IDE 40 pin (at ... centronics connector too, so I can't see that helping a SCSI device. ... guess is that it is for transmitting IDE data and power over a 50-pin ... standard 40 pin IDE plug and a standard Molex disk power plug (socket ...
    (comp.periphs.scsi)
  • Re: Cloning
    ... able to recognize the other IDE and was able to transfer data. ... I don't have to do any updating 2010 when the new windows OS will ... I have a 40 gig disk where my XP Pro is lying ... Windows does not have any inbuilt tools for cloning. ...
    (microsoft.public.windowsxp.general)
  • Re: Reihenfolge der Festplattenerkennung
    ... IDE/SCSI würde die erste IDE Platte mit 0x80, ... Erst dann kämen die SCSI mit z.B. 0x83. ... Defines non-standard parameters for the specified disk. ... The BIOS numbers your disks 0x80, 0x81, etc. and it is impossible to decide which Linux disk corresponds to which BIOS disk, so if you have an unusual setup you need to state the correspondence between Linux disks and BIOS disks. ...
    (de.comp.os.unix.linux.hardware)
  • Re: Difference between IDE and SCSI ??
    ... IDE stands for Intelligent Drive ... This was the first attempt to standardize the interface between mass ... owned a Northstar single density hard-sectored 5.25" disk system for my ... where the drives plug directly into the frame. ...
    (Fedora)