Sysprep reset to defaults Settings
From: Tomy (Tomy_at_discussions.microsoft.com)
Date: 06/18/04
- Next message: Carey Frisch [MVP]: "Re: Install doesn't assign drive letter to slave drive"
- Previous message: smcroy: "Install doesn't assign drive letter to slave drive"
- Next in thread: Carey Frisch [MVP]: "Re: Sysprep reset to defaults Settings"
- Reply: Carey Frisch [MVP]: "Re: Sysprep reset to defaults Settings"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 18 Jun 2004 06:56:01 -0700
When I run sysprep on a PC and reboot the pc back up after the image is finished. Why does the cmdcons and RDP settings reset to the default setting? The setting are the why I want them before I run sysprep.Also it disables the HelpAssistant account. is there a cmd that can be ran to stop the reset or after the image is loaded that we can run?
- Next message: Carey Frisch [MVP]: "Re: Install doesn't assign drive letter to slave drive"
- Previous message: smcroy: "Install doesn't assign drive letter to slave drive"
- Next in thread: Carey Frisch [MVP]: "Re: Sysprep reset to defaults Settings"
- Reply: Carey Frisch [MVP]: "Re: Sysprep reset to defaults Settings"
- Messages sorted by: [ date ] [ thread ]
Loading
