Re: XP setup cannot detect hard disks
From: Uncle Stewie (whoever_at_whatever.com)
Date: 03/01/04
- Next message: Kent_Diego: "Re: XP Very slow"
- Previous message: Carlos F: "XP setup cannot detect hard disks"
- In reply to: Carlos F: "XP setup cannot detect hard disks"
- Next in thread: Carlos F: "Re: XP setup cannot detect hard disks"
- Reply: Carlos F: "Re: XP setup cannot detect hard disks"
- Messages sorted by: [ date ] [ thread ]
Date: Mon, 1 Mar 2004 14:11:52 -0600
You will need to get the driver for your raid controller from the
manufacturer...
When the setup begins... press F6... and it will prompt you for any "Mass
Storage Controller Drivers"... follow the instructions and have the driver
ready on a floppy disk!
"Carlos F" <car_lost@yahoo.com.remove.this> wrote in message
news:%23quVaj8$DHA.2448@TK2MSFTNGP12.phx.gbl...
> Hello,
>
> I keep getting the dreaded "setup did not find any hard disk drives
> installed in this computer" error message when i try to install windows xp
> pro.
>
> The computer is as follows:
>
> - intel p4
> - intel S845WD1h motherboard
> - the board has an integrated Promise PDC20267 IDE RAID controller
> (FastTrack 100)
> - two 80 GB hard drives connected to the RAID controller - configured as a
> single mirrored drive
> - this computer was configured with Windows 2000 Pro and Windows 2000
> Advanced Server. I used fdisk to delete all the partitions.
>
> I originally tried to run the XP install from the CD from Windows 2000
> Advanced Server and ran into the "Stop 0x0000007B or
> INACCESSIBLE_BOOT_DEVICE" error. I consulted the MSDN article covering
this
> issue (article # 324103). As per the article I did a virus scan. I found
the
> machine was rife with viruses - the person that used the machine before
had
> apparently not been too careful about cleaning the box. In order to save
> time and clean the machine of any viruses I fdisked it. I then updated the
> BIOS to version 8 from the Intel site and I downloaded the RAID controller
> drivers from the Promise site.
>
> I ran the install process again by booting to the CD and hit F6 to specify
a
> custom RAID controller. I selected the FastTrack 100 driver from the list
> the setup displayed. 10 seconds later setup asked what kind of setup to
run
> (XP install, repair XP install using recovery console etc). I selected to
> set up XP now. It then stated that setup did not find any hard disk drives
> installed in this computer. I have subsequently tried running the setup
in
> a 100 different permutations with no change in the end.
>
> I suspect that the controller, hard disks and the cables are ok. I am
able
> to access and configure the disks via the RAID controller BIOS. The
> computer BIOS picks up the mirrored drive and lists it as an available
hard
> drive. Also, when the machine was running windows 2000 pro (which was
right
> before i tried installing XP) the mirrored drive was running just fine. I
> also checked the controller cables and the jumpers and everything is ok.
>
> Any suggestions? I am about to pull out what is left of my hair.
>
> Carlos
>
> --
> Carlos Fernandez
> Touzon Technologies, Inc.
> Voice - (703) 725-1765
> Fax - (703) 997-1093
> Email - cfernandez@touzon.com
> www.touzon.com
>
>
- Next message: Kent_Diego: "Re: XP Very slow"
- Previous message: Carlos F: "XP setup cannot detect hard disks"
- In reply to: Carlos F: "XP setup cannot detect hard disks"
- Next in thread: Carlos F: "Re: XP setup cannot detect hard disks"
- Reply: Carlos F: "Re: XP setup cannot detect hard disks"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
