Re: CHKDSK not repaing bad sector?

Alan

Chkdsk does not repair bad sectors. It places a marker to stop the
system accessing the bad sector. A few bad sectors is not a problem. It
becomes a problem if the numbers increase every time you run chkdsk. In
this situation the best solution is to replace the hard drive.

You say D and E drives have no bad sectors? Are they separate drives or
partitions of a single hard drive containing three partitions, C, D and
E?

In your situation you need to make sure important data is regularly
backed up to removable media. Also now is the time to check you have a
Windows XP CD you can use to do a new install on a new hard drive should
that become necessary.

Another way to investigate your hard drive is to use HD Tune.

Try HD Tune only gives information and does not fix any
problems.

Download and run it and see what it turns up. You want HD Tune
(freeware) version 2.55 not HD Tune Pro (not Freeware) version 3.00.
http://www.hdtune.com/

Select the Info tabs and place the cursor on the drive under Drive
letter and then double click the two page icon ( copy to Clipboard )
and copy into a further message.

Select the Health tab and then double click the two page icon ( copy to
Clipboard ) and copy into a further message. Make sure you do a full
surface scan with HD Tune.

--



Hope this helps.

Gerry
~~~~
FCA
Stourport, England
Enquire, plan and execute
~~~~~~~~~~~~~~~~~~~



AlanDavidson wrote:
I ran CHKDSK /f /r on my C: drive.

The event log said "4 KB in bad sectors".

This is the first bad sector I have seen on any hard drive for about
10 years, so I repeated CHKDSK /f /r in order to verify that the
sector had been repaired.

In fact the event log showed the same message for the new date and
time.

I ran CHKDSK /f /r for a third time. Same message.

So the bad sector is not being repaired.

What shall I do now?

BTW1: my laptop (2 years old) seems to be running fine. I have not
noticed any problems.
BTW2: The D: and E: drives show no bad sectors.


.

Relevant Pages

  • Re: Check Disc wont complete from "My Computer"
    ... No damaged sectors found on scan. ... HD Tune: IC35L080AVVA07-0 Health ... No you run Disk Defragmenter after running Disk CkeanUp and Chkdsk. ... cluster is in use, CHKDSK allocates a new cluster to do the job of the ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: Check Disc wont complete from "My Computer"
    ... Below are the results of that HD Tune up Readout ... No you run Disk Defragmenter after running Disk CkeanUp and Chkdsk. ... for bad sectors in the volume's free space. ... cluster is in use, CHKDSK allocates a new cluster to do the job of the ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: Check Disc wont complete from "My Computer"
    ... Uninstall HD Tune -Start, Control Panel, Add / Remove Programs.eli ... No you run Disk Defragmenter after running Disk CkeanUp and Chkdsk. ... CHKDSK always reads sectors that are ... cluster is in use, CHKDSK allocates a new cluster to do the job of ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: MS Office re-install to overcome Loading Front Page start-up
    ... how do I best back up everything on the laptop? ... Bad sectors do occur and you can use chkdsk to mark ... On other occasions you can find further bad sectors each time ... You want HD Tune ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: MS Office re-install to overcome Loading Front Page start-up
    ... On other occasions you can find further bad sectors each time you run chkdsk until the disk fails. ... Unless you find no further bad sectors after fixing with chkdsk the problem is that disk failure can occur at any time. ... You want HD Tune ...
    (microsoft.public.windowsxp.perform_maintain)