Re: Booting error

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

I forgot to mention about boot.ini.
Here you go:

[Boot loader]
default=multi(0)disk(0)rdisk(0)partition(1)WINDOWS
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)WINDOWS='Microsoft Windows XP
Professional" /fastdetect /Noexecute=OptIn

Check All Boot Parts::
It appears that all BOOT.INI lines for Microsoft operating systems are OK.

Any suggestion? TIA. Craig






"David Candy" <.> wrote in message
news:u64Ij$aYGHA.4836@xxxxxxxxxxxxxxxxxxxxxxx
It normally tells you on the line above saying press F1. And f1 shouldn't be
having anything to do with windows. That should be your BIOS.

--
--------------------------------------------------------------------------------------------------
How to lose a war in Iraq
http://webdiary.com.au/cms/?q=node/1335#comment-48641
=================================================
"Craig" <machocraig@xxxxxxxxxxx> wrote in message
news:%23JHnB7aYGHA.3444@xxxxxxxxxxxxxxxxxxxxxxx
I opened up my Dell tower.
Tested and confirmed that jumper sets for C and D driver were correct.
There was only one IDE cable which DVD driver was the master.

Again, when I start the computer by hitting power button, WinXP screen
opens
up smoothly.
As described before, the problem starts when "re-booting" or new software
was installed (and rebooted).
But if I hit F1, it opens up windows XP screen. The question is what
causes the booting error which requires hitting F1.
Thanks again. Craig.






"Thota Umesh" <thotaumesh@xxxxxxx> wrote in message
news:O7OAxhTYGHA.3448@xxxxxxxxxxxxxxxxxxxxxxx
this might be a jumper releated issue! if u are connecting 2 devices on a
single ide make sure one has a jumper else they wont work!

Hope this helps...,
Umesh Thota
www.windowsworkshop.com

"Craig" <machocraig@xxxxxxxxxxx> wrote in message
news:ehKjxWPYGHA.3448@xxxxxxxxxxxxxxxxxxxxxxx
My computer is run on WinXP Pro SP2 and it has two separate C- and
D-harddrive.
I am getting booting error soon after replacing the old DVD burner with
a
new Pioneer DVD burner,
The error occur ONLY when I restart my computer under Start
Shutdown>Restart.
The error message is:

Secondary hard disk drive ) not found
Strike the F1 key to continue, F2 to run
the set up utility.

On the other hand, when I start computer from power button on tower, no
error was shown.
I am wondering how to fix his inconvenient problem. TIA.

Craig











.

Quantcast