Re: Missing or corrupted file - ntoskrnl.exe
From: PVR (peterv666_at_adelphia.net)
Date: 11/04/04
- Next message: PMurray: "Re: Going to ask"
- Previous message: Jim Macklin: "Re: multilingual option"
- In reply to: PVR: "Missing or corrupted file - ntoskrnl.exe"
- Messages sorted by: [ date ] [ thread ]
Date: Thu, 4 Nov 2004 08:01:20 -0500
My problem is that whatever I do always results in the "missing or corrupted
ntoskrnl" message. I can reinstall Windows and everything works OK. HOWEVER,
When I Restore the registry from my backup set and restart I get the message
above. I am using the Full backup from last May so I doubt the registry in
the backup is corrupt.
I am going to try the approach suggested by Dave. I have tried P. A. Bear's
suggestion but I never receive an opportunity to use the "R" key as shown in
my first post.
I appreciate the help from Bear and Dave.
Peter.
"PVR" <peterv666@adelphia.net> wrote in message
news:Ytednay1-s8TWBXcRVn-qA@adelphia.com...
>I use WindowsXP/SP2 in a tower with P4/2.4. Yesterday morning without any
> warning my machine would not start Windows. Instead I received a message
> indicating that Windows could not start because of a missing or corrupted
> ntoskrnl.exe. This file should be reinstalled.
>
> I went to MS Knowledge Base 314477 and chose Method Three for repair. The
> PC
> did not respond as expected according to KB 314477. Instead I received a
> blue screen with three options - 1). Setup XP on the selected item. 2).
> Create a partition. 3). Delete a partition. Below this was a box with
> "Unknown Disk. (There is no disk in this drive.) 76317 MB Disk 0 at Id 0
> on
> bus 0 on atapi [MBR]." Below this was a highlighted line with
>
> C: Partition1 (System) [NTFS] 76317 MB (63264 MB free)
>
> I couldn't do anything but opt for item 1, Setup XP on the selected item.
> (This completely removed all my data and apps but I did have a full backup
> from May and several backups of Changed Files up to Nov. 1.) A fresh
> install
> of XP was obtained and I installed the backup software (Backup MyPC,
> StompSoft). The PC started normally.
>
> I started the full Restore, the first part of which was System State. I
> received a message that the Registry had been restored and I should
> restart
> the PC. When I did this I received the "missing or corrupted ntoskrnl.exe"
> message again.
>
> How do I get out of this "loop" and perform a full Restore of my apps and
> data?
>
> I appreciate all the help I can get on this.
>
> Peter.
>
>
- Next message: PMurray: "Re: Going to ask"
- Previous message: Jim Macklin: "Re: multilingual option"
- In reply to: PVR: "Missing or corrupted file - ntoskrnl.exe"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
