Re: New NIC - Zero Packets

Tech-Archive recommends: Fix windows errors by optimizing your registry


"smlunatick" <yveslec@xxxxxxxxx> wrote in message
news:87f10036-a71d-4954-908a-7985ac54fb81@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
On Nov 22, 4:45 pm, "JRS" <j...@xxxxxxxxxxxxxxxxx> wrote:
I have put a new D-Link DFE 538TX in my XP Pro SP2 system as I think
there
was a problem with the old on board Marvell Yukon card. Everything seemed
to
go well and the drivers were installed fine. However, even though the
settings are identical to the Marvell card (apart from using an assigned
IP
address of 192.168.1.123 instead of 192.168.1.100) there seems to be no
packets being sent or received when I look at the status of the
connection.

It all seems connected to the router fine and have been assigned the
correct
address (looking at status/support) and a repair reports no problems.

Enabling or disabling the old Marvel NIC makes no difference.

I have tried various cables in case that is the problem, including known
good ones.

Am I looking at the new card being dodgy or is there something else I can
do. I do find networking a little mysterious!

TIA

Jon

What, if any, firewall software / anti-virus system do you have on
this PC?

NOD32 and Sygate but disabling them makes no difference

Jon


.

Relevant Pages

  • Re: New NIC - Zero Packets
    ... settings are identical to the Marvell card (apart from using an assigned IP ... packets being sent or received when I look at the status of the connection. ...
    (microsoft.public.windowsxp.network_web)
  • Re: OSR6 & Network Card
    ... That did the trick for the Marvell. ... network card), how do I add that particular card to ... adapted corresponds to what driver? ... I'm attempting to install OSR6 for inhouse testing ...
    (comp.unix.sco.misc)
  • Re: High DPC Use and a Method to Reboot a network card?
    ... gigabit ethernet chipsets. ... use a Marvell chipset, and that Marvell uses the same driver code base ... When you thought to yourself "hmm, I switched the card, and I still ... I don't have a choice in the matter. ...
    (microsoft.public.development.device.drivers)
  • Re: Support for SAS/SATA non-RAID adapters
    ... It's based on Marvell 88sx8061 chipset. ... card hard and under load this card showed noticeably slower transfer ... slot on-board. ... but those went away after updating firmware to 1.29.0.0. ...
    (freebsd-stable)
  • Re: Promise SATA controllers & FreeBSD-7
    ... There is the supermicro card based on Marvell 88SX6081. ... 0xE9758B7D or 'Peter Schuller ' ...
    (freebsd-current)