Re: Can not connect to internet after ME to XP upgrade

Try:

1. Open IE, click Tools/Internet Options/Connections tab.

2. Select Never dial a connection.

3. Click LAN settings button and clear all check boxes.

4. If the above does not work, open a command prompt and:

ping 4.2.2.1 ENTER.

5. If #4 works, try:

ping yahoo.com ENTER

If #4 works and #5 does not, or neither works; try manually setting your IP
address, subnet mask, default gateway and primary DNS server. Use the IP of
your ISP's DNS server for primary DNS:

http://www.microsoft.com/resources/documentation/windows/xp/all/proddocs/en-
us/sag_tcpip_pro_manualconfig.mspx?mfr=true

Doug Sherman
MCSE, MCSA, MCP+I, MVP

"Shail" <Shail@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:9400E56C-6B7F-4B8B-A85A-903B72824932@xxxxxxxxxxxxxxxx
Hello,

I upgraded (not fresh install) my home desktop from WinME to WinXP and
since then I am unable to connect to internet. I am connecting via LAN
using
cable modem. It has been working fine before upgrade but am unable to
connect
since upgrade. Here is my desktop info:

Compaq Presario S5005
Pentinum III 933 MHz
256 RAM
60 Gb Hard drive
Network card is "SMC EZ 10/100 SMC1211TX".

I have checked everything. Network connection is enabled and XP says
working. I am able to get IP address (tried ipconfig). It shows me a valid
IP address assiged by my Belkin wireless router (192.168.2.72). I am
unable
to do "ipconfig /renew", it syas unable to renew IP address. I am unable
to
connect to net via IE. I have checked all IE settings and everything looks
fine.

I have even tried to disable the LAN connection and re-enabled but still
same problem.

I ran the Network Setup Wizard but the last page showed following:

Cannot Complete the Network Setup Wiard
An error occurred during configuration of the network on this computer.
You can configure your network manually, or you can run the wizard again
with different settings.
To close this wizard, click Finish.

On the "Select a connection method" screen I selected the first option
i.e.
"This computer connects directly to the internet. The other computers on
my
network connect to the Internet through this computer."

In nsw.log file, except for few other informative statements (as to
enabling
this and starting that), the only one close to error message looks like
this:
"Adapter configuration for home networking failed."

Can somebody pl. help me figure what is wrong? How to diagnose
and fix the problem? Any comments, suggestions or pointers will be much
appreciated.

PS: I have two other computers connected to the same router and everything
is working fine on those. The problem is only on this one that I upgraded
from ME to XP. I had tried to connect this computer directly to cable
modem
but same problem. When I do this, though the IP address is now assigned by
comcast but still can not access net.

Regards
Shail


.

Loading