Printer network drops out on power failure

I have a USR 5461 router and print server connected to a cable modem. I
have three laptops networked via ethernet, and the net always runs fine
after a power failure. But I have to re-install the network printer
(Konica Magicolor 2300DL) on each laptop everytime there is a
disconnect of the power to the printer server within the USR 5461. I
am running Windows 2000, XPhome ans XPpro, and I just bought a UPS
which is connected to the router/printer server. I hope this will solve
my problem vis a vis the printer server dropping out after a
disconnect. Any helpful comments welcome....

Richard N. Hinton

.

Relevant Pages

  • Re: SBS 2003 Misconfigured?
    ... I've thrown quite a bit at them, and just have to disagree that they are inherently less secure than the netgear. ... setup DHCP and I have also gone in and manually created a new scope ... when I first used the Netgear router with SBS 2003, ... than one SBS server in a company makes no sense. ...
    (microsoft.public.windows.server.sbs)
  • Re: Cannot connect to RWW from home PC
    ... eth0 172.26.0.1/16 Extra none ... That would be the address you need a DNS record for. ... One question - if I reset the Thomson Router will that clear all the ... Heres' the info for our server: ...
    (microsoft.public.windows.server.sbs)
  • Re: NLB Cluster - Ping fails or long time to reply from outside local subnet - SOLVED
    ... Windows Server 2008 Readiness Team ... I was feeling nervous about our teaming-capable adapter as I read it might be sending out heartbeats, so I disabled it AND configured the cluster on a separate DLink card in multicast mode. ... I am losing the plot with NLB, I have spent a week trying to get it working. ... I thought that the litmus test was that the router functions fine when no NLB is installed, but when it is, things start going screwy. ...
    (microsoft.public.windows.server.clustering)
  • Re: SBS 2003 Misconfigured?
    ... Yeah, maybe it's not that different from the Netgear, for all that. ... that when I first used the Netgear router with SBS 2003, ... tech spend 4+ hours on my system, and then tell me to enable DHCP ... more than one SBS server in a company makes no sense. ...
    (microsoft.public.windows.server.sbs)
  • Re: Cannot connect to RWW from home PC
    ... That would be the address you need a DNS record for. ... You say "And in the router you need to forward to your external nic IP" ... Still can't telnet to any of your ports at your public ip address. ... Heres' the info for our server: ...
    (microsoft.public.windows.server.sbs)