Re: Let Windows configure my wireless connection

Many thanks for your response Richard.........just tried it out but no luck
I'm afraid. Exactly the same results. Seemed a logical suggestion but really
not sure where to go from here.
Thanks again.
Phil

"Richard G. Harper" wrote:

> Sounds like you have two control programs fighting over configuring the
> wireless card - the Windows WZC service and whatever service your wireless
> card has installed. The cure for this is to decide which one you want to
> control the card, then disable the other. For example, if you want to use
> the wireless card's configuration program you must disable the Wireless Zero
> Configuration service in the Service MMC Snap-in (Start, Run, SERVICES.MSC).
> If you want Windows to control the card, leave WZC alone and disable the
> card's configuration utility.
>
> --
> Richard G. Harper [MVP Shell/User] rgharper@xxxxxxxxx
> * PLEASE post all messages and replies in the newsgroups
> * for the benefit of all. Private mail is usually not replied to.
> * My website, such as it is ... http://rgharper.mvps.org/
> * HELP us help YOU ... http://www.dts-l.org/goodpost.htm
>
>
> "Phil.T" <PhilT@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
> news:5599051B-E855-4485-908A-39E2EF3663E6@xxxxxxxxxxxxxxxx
> >I cannot get a wireless connection to work between my laptop and Linksys
> > wireless-g router. However, if I "un-check" the "let windows configure my
> > wireless connection" within wireless properties, then immediately I have a
> > connection! But, on closing down and re-booting once again no wireless
> > connection is operable until I once more "check" the same tick-box and
> > then
> > "un-check" it. Any ideas please where I'm going so hopelessly wrong in
> > what
> > I presume is a configuration issue?
> > Thanks
> > Phil
>
>
>
.

Relevant Pages

  • Re: Need help with wireless config.
    ... eth0 no wireless extensions. ... I think I should be able to browse to 192.168.1.1 and see the router set up screen from this computer via the Linksys WMP54G adapter card. ... It was recognized on boot, designated eth1, and when I set it up and activated it using my WEP configuration, it worked immediately. ...
    (Fedora)
  • 3COM Wireless PCMCIA not connecting on IBM X21 - Newbie HELP please!
    ... Everything works fine and wonderful but I can't get the 3COM Wireless LAN PC ... Network card. ... The KWiF configuration editor's "Autodetect interface" did find a device ... Based on my experience with Windows, this is likely to be IRQ ...
    (comp.os.linux.networking)
  • Re: sitecom wireless lan and SuSE 9.2
    ... I want to make a connection to a wireless router. ... > The wireless lan card is recognized by YAST, but I can not make a ... you are in the wireless card configuration in YaST, then, when you have ...
    (alt.os.linux.suse)
  • Re: Let Windows configure my wireless connection
    ... >> wireless card - the Windows WZC service and whatever service your ... >> card has installed. ... >> Configuration service in the Service MMC Snap-in (Start, Run, ... >> * PLEASE post all messages and replies in the newsgroups ...
    (microsoft.public.windowsxp.network_web)
  • Re: wireless configuration problem
    ... I also have the CISCO 350 card. ... Basically, SUSE ... configuration is handled under the /etc/sysconfig/network directory. ... The wireless support scripts dynamically assign the wireless card ...
    (alt.os.linux.suse)