Re: networking set up
From: Richard G. Harper (rgharper_at_email.com)
Date: 08/27/04
- Next message: Richard G. Harper: "Re: dns error"
- Previous message: Richard G. Harper: "Re: HTTP Tunnelling"
- In reply to: david_at_discussions.microsoft.com: "networking set up"
- Next in thread: Eric Cross [MVP]: "Re: networking set up"
- Messages sorted by: [ date ] [ thread ]
Date: Fri, 27 Aug 2004 17:38:17 -0400
Do this:
1. Open up a command prompt.
2. Type the following and press Enter:
net stop spooler
3. Run the Network Setup Wizard.
4. Go back to the command prompt and type the following and press Enter:
net start spooler
5. Enjoy your network.
-- Richard G. Harper [MVP Win9x] rgharper@email.com * PLEASE post all messages and replies in the newsgroups * for the benefit of all. Private mail is usually not replied to. * HELP us help YOU ... http://www.dts-l.org/goodpost.htm <david@discussions.microsoft.com> wrote in message news:18bf01c48c5c$e1317050$a301280a@phx.gbl... >I am trying to set up a network with my computers. When > I try to run the wizard for one of them I keep getting > splloer subsystem app error and it will not finish the > set up. The other computer is set up
- Next message: Richard G. Harper: "Re: dns error"
- Previous message: Richard G. Harper: "Re: HTTP Tunnelling"
- In reply to: david_at_discussions.microsoft.com: "networking set up"
- Next in thread: Eric Cross [MVP]: "Re: networking set up"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
