Re: Setting up network - Spooler SubSystem error
From: Eric Cross [MVP] (encross_at_eudoramail.com)
Date: 06/06/04
- Next message: Dave Mitchell: "Internet Connection Sharing problem"
- Previous message: Ritchie: "TCP/IP settings keep dropping, corruption?"
- In reply to: Sheryl: "Setting up network - Spooler SubSystem error"
- Next in thread: Sheryl: "Re: Setting up network - Spooler SubSystem error"
- Reply: Sheryl: "Re: Setting up network - Spooler SubSystem error"
- Messages sorted by: [ date ] [ thread ]
Date: Sun, 6 Jun 2004 07:14:35 -0500
Greetings Sheryl,
You're not the only one with this problem but there is a workaround.
Usually, these errors occur due to printer even though your printer is
functioning properly. Open the Command Prompt and stop the Spooler Service
before running the Network Setup Wizard. Here's what you do:
1. Open the Command Prompt.
2. At the command prompt, type "net stop spooler". Then press ENTER.
3. Run the Network Setup Wizard again to complete the network setup.
4. After you are finished, then restart the spooler service. To restart the
spooler service, open the Command Prompt and type "net start spooler". Then
press ENTER.
_________________
Eric Cross, MS-MVP (Windows Networking)
"Sheryl" <4okakind@verizon.net> wrote in message
news:18c3501c44b76$86bbb850$a101280a@phx.gbl...
> I'm trying to set up a network w/2 machines both on
> Windows XP Home. Every time I try to use the wizard on
> my desk top, I got partially through it before I encouter
> an error. . .
> "Spooler SubSystem App has encountered an error and needs
> to close" --- once it does this, the wizard cannot
> complete the setup.
>
> All I can find on help is the suggestion to make a
> register change which sounds scary to me.
>
> FYI - a few months ago I did have a spooler problem with
> this machine with a particular printer that crashed --
> however, it hasn't been any issue in ages.
>
> Any suggestions???????? Thanks in advance.
- Next message: Dave Mitchell: "Internet Connection Sharing problem"
- Previous message: Ritchie: "TCP/IP settings keep dropping, corruption?"
- In reply to: Sheryl: "Setting up network - Spooler SubSystem error"
- Next in thread: Sheryl: "Re: Setting up network - Spooler SubSystem error"
- Reply: Sheryl: "Re: Setting up network - Spooler SubSystem error"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
