Re: Apply project to other source?

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

Hi Arne,

Check the Managing > Source Files > page of my site... you might be able to
make a much high quality WMV file and substitute it for the one you
captured, with it working in your existing project.
--
PapaJohn

Movie Maker 2 and Photo Story 3 - www.papajohn.org
Photo Story 2 - www.photostory.papajohn.org
..
"Arne" <Arne@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:2F8FC230-73EE-4B62-BE48-1F65E9BEBFE0@xxxxxxxxxxxxxxxx
> This is fine for new projects but not much help for my existing project. I
> had hoped there was a way I could avoid repeating the whole editing
> prosess
> with an AVI source. Since the source will be equal when it comes to the
> length of each clip it should theoretically be possible to edit the
> project
> file and replace the old source fil e with a new AVI source.
>
> Arne
>
> "dickmr" wrote:
>
>> Hi Arne....when you use the Movie Maker 'capture' function you will come
>> to a
>> page asking you to choose your video setting. At this point specify
>> that
>> your video be saved in DV-AVI and your DV video will be saved in the
>> original
>> quality of you video.
>> This will facilitate further editing and again saving your completed
>> video
>> to DV-AVI format when you save the movie. Understand, however, that
>> your
>> saved video files will be huge and consume up to 178 megabyte per minute
>> of
>> video...so just make sure you have enough hard disk space. After you
>> save
>> your edited file in DV-AVI to make a dvd, you can also save it in 'high
>> quality ntsc' to hold on your computer...and then go and delete the huge
>> file
>> you created originally. Good luck.
>>
>>
>> "Arne" wrote:
>>
>> > Hi!
>> >
>> > I am new to Windows Movie Maker.
>> > I made a project where I chose to import DV to wmf. After finishing the
>> > project and not beeing satisfied with the quality (espacially for
>> > making
>> > DVD-video) I regret editing in wmf-format. Now if I cound import DV to
>> > avi
>> > and apply the project settings to this file then everything would be
>> > great.
>> > Is this possible? I guess if the .mswmm project file could be edited
>> > then I
>> > could change the source name.
>> >
>> > Arne


.

Quantcast