Re: Xp install problem

Tech-Archive recommends: Fix windows errors by optimizing your registry

Chris wrote:
Hi,

I am attempting to install xp after fitting a new HDD following a
"failure" of the old one. I have removed all of the add-on pci cards
so the system is down to the bare bones required. I have been running
this version of XP with no problems for 3 years so I know the fault
is not
with the version

When I reach the point during the install where the "install devices"
starts, I get the stop code 0x000000BE. Tried a few options but I
cannot seem to fix this problem. The HDD is the same size and make as
the old one.

Any advice would be appreciated

Using this set of instructions:

http://www.michaelstevenstech.com/cleanxpinstall.html

at what point do you get the stop code?

Which options have you tried?


.

Relevant Pages

  • Re: Xp install problem
    ... When I reach the point during the install where the "install devices" ... The HDD is the same size and make as the old ... reinstall "all of the add-on pci cards" that you removed and then try to ... worthwhile to remove the graphics card, ensure your onboard graphics ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Xp install problem
    ... When I reach the point during the install where the "install devices" ... The HDD is the same size and make as ... reinstall "all of the add-on pci cards" that you removed and then try ... Does your motherboard support onboard graphics? ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: New build - halt on ACPI Controller
    ... on the hdd from a previous install attempt. ... landed up using the rear panel mains isolator switch to switch it off as ... The use of partition analysis and repair tools unearthed a further two ...
    (uk.comp.homebuilt)
  • Re: Xp install problem
    ... Anna wrote: ... I am attempting to install xp after fitting a new HDD following a "failure" of the old one. ... When I reach the point during the install where the "install devices" starts, I get the stop code 0x000000BE. ... If so, it would be worthwhile to remove the graphics card, ensure your onboard graphics capability is enabled and see if the install will succeed. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Xp install problem
    ... I am attempting to install xp after fitting a new HDD following a ... When I reach the point during the install where the "install ... graphics/video card. ... You're certain all your connections & configuration of components ...
    (microsoft.public.windowsxp.help_and_support)