RE: "Help and Support" and "Restore Point UI" do not open.

Helpfix.txt: http://www.geocities.com/marfer_mvp/Helpfix.txt

After help is running, turn off sys restore, and restart, and then turn it
back on. This will lose all old points, but the restore will work again.
start/run, type:
sysdm.cpl
see restore tab.
--
Was this helpful? Then click the "Yes" button below. Voting helps the web
interface. http://www.microsoft.com/wn3/locales/help/help_en-us.htm#RateAPost

Mark L. Ferguson


"Mitchell" wrote:

I've had some problems, after a power failure, during a software installation
on XP Pro.

The result is that both "Help and Support" and "Restore Point UI" utilities
do not open. (The former runs with a blank scree, the latter does run at
all.) Thankfully, I created a restore point (and I presume that this backs up
the registry too) but NOW I cannot go back to restore to that restore point.

How can I get my "Help and Support" and "Restore Point UI" utilities working
again?

I did an sfc check and all seems OK.

Any help would be REALLY appreciated :-(
.