Re: unable to install XP on new HD



On Tue, 11 Dec 2007 18:36:03 -0800, elly <elly@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote:

Hello,
After installing a new HD to replace non-working HD on an older PC I
proceeded to install XP Pro but a few minutes into setup I got a message that
a file could not be extracted from the cd I think it was cab.driver or
something like that I cannot acces that information now, I retried but could
not be done so the next option was to exit setup and try again which I did,
here comes the problem when I tried to reboot to start XP set up again the
system will go past the bios boot but stops before loading XP from CD rom I
get a black screen with the following message NTLDR missing press alt ctrl
del to restart, but It will not work I keep on getting the same message
everytime, I have tried a different CD rom but the same, I am stuck not being
able to get past this problem. My PC is a pentium 4, bios seems to be
working ok I
setted it up to boot from cd and the new HD has been detected. Please help
Thank you for your support
Elly

The boot sequence in your motherboard's CMOS settings is set to boot from the hard
drive before checking the CD-ROM drive for a bootable CD. Since your hard drive now
has an aborted installation of Windows XP, the boot process is getting hung up there
before ever going out to try to boot from the CD. Go into the BIOS, find the setting
for boot sequence and make the CD-ROM drive the first boot device. I always set the
following sequence: #1. CD-ROM Drive(s) #2. 3.5" Floppy drive (or USB) #3. Main Hard
Drive.

It would also be a good idea to clean the XP CD and run a cleaning CD in the CD-ROM
drive you're trying to boot from. After that's all done, restart and see if the
installation continues. If not, just delete the partition you created, reformat it
and start all over again.

Have fun!
HJS
.



Relevant Pages

  • [OT] Machine wont boot
    ... But then at some point the computer stopped booting completely --- bios starts ... the dvd drive button does eject if pressed. ... This situation is repeatable with Fedora 8 dvd and Windows XP installation ... A computer usually does boot completely or does not boot at all. ...
    (Fedora)
  • Re: Boot process of i386
    ... >DVD-player didn't boot properly and wouldn't start the XP ... Suse installation CD ... >work properly) that wipe out the entire hard disk. ... >* BIOS tries to load boot code from peripherials in BIOS setting order ...
    (comp.os.linux.hardware)
  • Re: remove driver
    ... from within XP setup as follows but note, this will wipe your hard drive ... Assuming your system is set to boot from the CD-ROM drive, ... To Setup Windows XP now, ... To Repair a Windows XP Installation using Recovery Console press R. ...
    (microsoft.public.windowsxp.device_driver.dev)
  • Re: Boot problem, copied Master
    ... If your system is set to be able to boot from the CD, ... Once you have pressed a key, setup should begin. ... with the option to setup Windows or Repair Windows Installation ...
    (microsoft.public.windowsxp.basics)
  • Re: XP install did not find hard drive
    ... > My desktop cannot boot up. ... I tried to reinstall windows XP. ... > My BIOS can recognize the hard drive. ... > any idea why BIOS can see hard drive, but installation software cannot ...
    (microsoft.public.windowsxp.general)