Re: Boot Up Problem



John - select F2 - in setup verify that drive detection is set "auto" and
that drives are recognized.

"John" <John@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:650E395D-AC9A-47EA-B540-D99E4AC8C0FD@xxxxxxxxxxxxxxxx
I am running XP and when I attempt to turn on my computer I get a message
that ways Drive 0 not found:Serial ATA, SATA-0.

The second message is "No boot device avaialble- Strike F1 to retry boot,
F2
for setup utility"

Any ideas what I should do?
--
John


.



Relevant Pages

  • Re: Reboot and select proper boot device problem NOTsolved
    ... Gigabyte GeForce 7300GT PCI Express. ... I have made sure the harddrive is the first boot device. ... I downloaded and ran diagnostics on both drives. ... I take it you're using a SATA drive? ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Reboot and select proper boot device problem NOTsolved
    ... Gigabyte GeForce 7300GT PCI Express. ... I have made sure the harddrive is the first boot device. ... I downloaded and ran diagnostics on both drives. ... I take it you're using a SATA drive? ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: Sata/IDE drive recognition problem
    ... While preparing to move a system from i386 to amd ... The CD installer select drives interface for 6.1 RELEASE ... Second Boot Device Hard Disk ...
    (freebsd-questions)
  • Please help ---Sata/IDE drive recognition problem
    ... The CD installer select drives interface for 6.1 RELEASE ... IDE Channel 0 Master WDC WD2000JB ... Second Boot Device Hard Disk ...
    (freebsd-questions)
  • Re: Windows bootup and Partioning Questions
    ... I did as you suggested and set the cd rom drive as the first boot device. ... After that, Windows is started again. ... You will have to use a good third party partition ... partioned into 2 drives, C and D drive with C as FAT32 and D as NTFS. ...
    (microsoft.public.windowsxp.help_and_support)