system not fully installed???

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance




i'm getting a blank screen when i try to boot up, i just did a system
restore. when i go into safe mode it sends a message "the system is not
fully installed. Please run setup again." Any suggestions?


--
fncbdy1
------------------------------------------------------------------------
fncbdy1's Profile: http://extremetechsupport.com/forum/member.phtml?userid=2597
View this thread: http://extremetechsupport.com/forum/showthread.phtml?t=371925

.



Relevant Pages

  • Re: crcdisk.sys driver wont load....cant boot into laptop
    ... Loading into Safe mode showed that it gets to the crcdisk.sys driver ... After this I was able to boot into Safe mode and normal mode, ... I then tried to install two updates but when I rebooted it has gone ... Then restore to factory condition by pressing the correct ...
    (microsoft.public.windows.vista.performance_maintenance)
  • Re: System wont restore
    ... into Safe Mode try using msconfig to troubleshoot the problem. ... disabling all the startup items and try to boot normally. ... When I try to restore the message is "unable to restore". ... program also runs in DOS (or command prompt) from a floppy. ...
    (microsoft.public.windowsxp.general)
  • Re: Server Down
    ... Ran auto system restore which failed right at the end with The recovery ... I now had a server I could boot into but was very poorly. ... Reboot but DNS/DHCP probs so again did restore but just wins and dns folders. ... Same situation in safe mode. ...
    (microsoft.public.windows.server.sbs)
  • Re: Stuck on blue loading screen
    ... Have you tried booting into Safe Mode, and just before the Safe Mode desktop ... a restore point from a date PRIOR to the infection? ...
    (microsoft.public.windowsxp.general)
  • Re: Monitor Settings were changed!
    ... Boot into Safe Mode (press the F8 key a couple of times on boot before the Windows logo ... the desktop or go directly to System Restore. ...
    (microsoft.public.windowsxp.general)