RE: Error whe trying to use jump drive
From: BAR (BAR_at_discussions.microsoft.com)
Date: 10/29/04
- Next message: Kelly: "Re: Content IE.5"
- Previous message: Vilma: "Re: Internet disconnecting"
- In reply to: atburt: "Error whe trying to use jump drive"
- Messages sorted by: [ date ] [ thread ]
Date: Thu, 28 Oct 2004 22:58:02 -0700
You can use Task Manager to end the installer.
Read the manul for the USB device and follow their instructions to the letter.
Typically USB drives do not need 3rd party software, however there are
exceptions.
Once the device is connected and 'installed' you will need to use initialse
and format the disk before you can access it to store and retrieve data.
To open Computer Management, click Start, and then click Control Panel.
Double-click Administrative Tools, and then double-click Computer Management.
You must be logged on as an administrator or a member of the Administrators
group in order to complete this procedure.
New disks appear as Not Initialized.
Before you can use a disk, you must first initialize it. If you start Disk
Management after adding a disk, the Initialize Disk Wizard appears so you can
initialize the disk.
"atburt" wrote:
> Whe I plug it in to the USB nothing happens. It makes the sound as if it is
> acknowledged but the dirve doesn't appear.
> When I go to the control pannel and try to add hardware is says "You can
> only install one device at a time. Anouther device installation is underway,
> when it is finished you can try this wizard again."
> What has happened? How do I kill the false install to the wizard?
- Next message: Kelly: "Re: Content IE.5"
- Previous message: Vilma: "Re: Internet disconnecting"
- In reply to: atburt: "Error whe trying to use jump drive"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
