Re: Access WIN98 files on slave disk
From: VManes (vmanes_at_N0SP&Mrap.midco.net)
Date: 08/28/04
- Next message: CS: "Re: Prefetch gone? - solution"
- Previous message: Isaac Khabaza: "Taskbar color"
- In reply to: JohnG: "Access WIN98 files on slave disk"
- Next in thread: JohnG: "Re: Access WIN98 files on slave disk"
- Reply: JohnG: "Re: Access WIN98 files on slave disk"
- Messages sorted by: [ date ] [ thread ]
Date: Sat, 28 Aug 2004 17:47:48 -0600
The old disk should show up as D: (or some further letter if you partioned
the new one into more than one) and you should be able to access the files
without any special actions.
If it's not showing up, check that it's found by your BIOS at bootup (did
you reconfigure the jumpers, if needed?)
Val
-- Bringing you BeadWizard Design Software www.beadwizard.com *************************** Practice safe eating -- always use condiments. *************************** "JohnG" <mlmpros@jwgmg.com> wrote in message news:OrY3nhVjEHA.2544@TK2MSFTNGP10.phx.gbl... Before installing XP with NTFS, I installed a new hard disk as master and moved my old disk containing WIN98SE to slave. How can I access the slave disk to retrieve my important files?
- Next message: CS: "Re: Prefetch gone? - solution"
- Previous message: Isaac Khabaza: "Taskbar color"
- In reply to: JohnG: "Access WIN98 files on slave disk"
- Next in thread: JohnG: "Re: Access WIN98 files on slave disk"
- Reply: JohnG: "Re: Access WIN98 files on slave disk"
- Messages sorted by: [ date ] [ thread ]
Relevant Pages
|
Loading