Re: Adding 2nd HD
- From: "Lil' Dave" <spamyourself@xxxxxxxxx>
- Date: Wed, 19 Nov 2008 04:21:44 -0600
As an addendum, if the master is a Western Digital, and, is jumpered to
master alone; it must be jumpered to master w/slave for the slave to be
"seen".
--
Dave
If it looks like fish, smells like fish, its not
a cantaloupe.
"Thomas Wendell" <tumppiw_nospam@xxxxxxxxxxx> wrote in message
news:uU6Hz5YSJHA.4764@xxxxxxxxxxxxxxxxxxxxxxx
Is the first drive set as Master or is it set as CS(cable select)?? If CS,
the slave has tobe that too.
Does diskmanager see the disk? If so, in siskmanager it needs tobe
partitioned and formatted...
(diskmanager = Start->Run = diskmgmt.msc )
--
Thomas Wendell
Helsinki, Finland
Translations to/from FI not always accurate
"desgnr" <desgnr@xxxxxxxxx> kirjoitti
viestissä:%23XMU5RYSJHA.3584@xxxxxxxxxxxxxxxxxxxxxxx
--------------------------------------------------------------------------------
I added a 2nd HD for storage.
I put it on the middle of the cable.
Set the jumper to Slave.
The drive is running but the PC does not see it.
When the PC is booting i see it say Primary HD & Secondary HD
Is there something i need to change in the bios?
.
- References:
- Adding 2nd HD
- From: desgnr
- Re: Adding 2nd HD
- From: Thomas Wendell
- Adding 2nd HD
- Prev by Date: Re: Switch box for four PC's / USB and DVI
- Next by Date: Re: Seagate(Acronis) cloning not working right.
- Previous by thread: Re: Adding 2nd HD
- Next by thread: Re: Adding 2nd HD
- Index(es):
Relevant Pages
|
