Re: Device not enumerated

Tech-Archive recommends: Speed Up your PC by fixing your registry

Your tagline separator prevents proper quoting, please remove it or bottom post. As to the problem PC, what issues do you see in the Device manager related to USB and the printer. Any "mystery" devices?


Quote:
I hooked theprinter to my laptop and everything worked as intended. I'm
wondering if the BIOS might be at fault. My mobo supports 4 usb ports and I
have a usb / firewire card that supports four more. The printer has been
plugged into both the mobo and card ports. Other devices connected to these
port work as advertised - scanner, card reader, and external hd.


"Bob I" wrote:

Bad usb cable?

RealGomer wrote:

> For some reason my Canon i550 USB printer will not work. When I try to load > the drivers, I get a message the port is not found. I've tried in three > different USB ports on my Gigabyte GA-K8NS-Pro mobo running WinXP Pro SP2. > When I ran a hardware analyzer, it said the device was not enumerated. All > other USB devices work fine. Suggestions? The Registry show the i550 all over > the place.
> > (Also posted to XP Printing)



.

Relevant Pages

  • Re: USB questions
    ... The purpose of the USB PC Cards is primarily to "upgrade" a PC that only has USB 1 ports to USB 2 ports, although obviously they can also be used to add more ports as well. ... The power jack on the cards, when present, is an input, without the input the card doesn't supply power to USB powered devices. ... Also, since what you need is 5 volts, supplies are fairly common and you do not need to use the supply, the supply cord or intended source that the card maker suggested ... ...
    (comp.sys.laptops)
  • Re: xD transfer speed through printer to computer
    ... Photosmart) which has built in card readers and a built in USB 2.0 port. ... My computer has no front USB ports, and the back ports are in use plus ... I decided to go the card reader route. ...
    (rec.photo.digital)
  • Re: usb flash drive locks up system??
    ... Seems usb conflicts are the first thing to check and if I'd found/remembered ... the scanner running usb, this problem would have been fixed immediately. ... I have a USB scanner plugged into pci usb card and that was ... have been known to blow out ports ...
    (microsoft.public.windowsxp.hardware)
  • Re: USB DEVICE NOT RECOGNIZED - ALL PORTS
    ... This seems pervasive, reading the USB comments. ... Does this PCI USB CONTROLLER go inside of outside of computer? ... card, would end up on the left hand side of this picture. ... to add five USB ports. ...
    (microsoft.public.windowsxp.hardware)
  • Re: High speed device plugged into non-high speed port
    ... > The motherboard has six onboard USB 2.0 ports that work fine. ... I then bought another VIA VT6202 PCI USB 2.0 card, ...
    (microsoft.public.windowsxp.hardware)