HDD

Tech-Archive recommends: Fix windows errors by optimizing your registry

I have 2 hdd's on an ata133 pci raid card___sometimes when booting after the
computer has been off for a few hours__it will not show the 2
hdd's__rebooting a couple of times they then show__I took out the jumper on
each hdd as sometimes the computer refused to boot until I pulled the power
plug from the slave hdd__the normal sys {2} HDD's master and slave are on
cable connect__all seems well in admin/ computer management_______jumper
pins are master 10 pin and slave 6 pin__not a real bother , but it's not
going to get any better___help or hint please______
Kind Regards From OZ


.

Relevant Pages

  • Re: "STOP 0x000000ED UNMOUNTABLE_BOOT_VOLUME" Error Message
    ... When you have the drive connected as slave and booting into XP (with your ... Are you looking in the correct My Documents directory. ... | I have had WinXP Pro installed on an 80G WD harddrive since April. ...
    (microsoft.public.windowsxp.general)
  • ATA_IDENTIFY no interrupt
    ... I just tried to install a 5.2.1 on several remote servers for testing ... While booting the harddisk isn't found properly but the drive is ... Master: no device present ... Slave: no device present ...
    (freebsd-current)
  • Re: Slave Hard-Drive probs
    ... XP Pro has been set as Master and old XP Home ... With your "old" drive connected to your XP machine as Slave and with the ... boot to the PM drive, ... booting to a Desktop. ...
    (microsoft.public.windowsxp.general)
  • Re: Slave Hard-Drive probs
    ... Thanks Anna, my post was more of an enquiry than a problem and you are right ... I did envisage that when I set up my old hardrive as a slave drive that I ... > booting to a Desktop. ... It's possible it may boot from the Slave position (after ...
    (microsoft.public.windowsxp.general)
  • Re: boot.ini
    ... "gadya" wrote: ... | Path in boot.ini affected by which drive you are booting from? ...
    (microsoft.public.windowsxp.basics)