Re: VIA AC97: mic and boxes want same "port" for the cable

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance

When you switched to XP you may have lost some motherboard specific
software. See if you can identify the motherboard and look for their web
site or the system manufactureers web site. On one of mine for instance,
the motherboard normally has
a green for line (sound) out, a blue for line in and a gray fore mic in.
But the configuration also allows me to change to two lines out and mic in
or three lines out from the control panel. Yours may have something
similar.


"Bob I" <birelan@xxxxxxxxx> wrote in message
news:e5aMdWLAGHA.2036@xxxxxxxxxxxxxxxxxxxxxxx
> Sounds like defective hardware to me.
>
> Jack.Hambabo@xxxxxxxxx wrote:
>
>> Hi,
>>
>> I bought a used celeron 2,9Ghz. It works fine. And I was able to use my
>> headset with the ubuntu live cd.
>> Now however I installed WinXP and all of a sudden both the microphone
>> and the boxes work only when I plug them into the left port (of the
>> typical three). They are not labeled.
>> Both sound and audio recording works fine, when one plugs the specific
>> cable into the left port. As I can't plug both into that port, I tried
>> putting the boxes inthere, and but the mic in one of the other ports.
>> When using Skype or the audio hardware test, I then get an acoustic
>> feedback getting louder and louder as soon as a volume treshold is
>> reached.
>> Moreover, I can sometimes tape my voice with "audiorecorder" very, very
>> quitely if I try shouting very loud. But that doesn't work all the time
>> (on the left port recording volume is fine).
>>
>> Any suggestions are very appreciated,
>> thanks,
>> Jack
>>
>


.

Relevant Pages

  • panic: APIC: Previous IPI is stuck
    ... pcibus 0 on motherboard ... <Parallel port bus> on ppc0 ... GEOM_MIRROR: Device mirror0: provider da0 detected. ... Disk da1 attached to usr2. ...
    (freebsd-stable)
  • Newest Stack-180 CP/M system with motherboard option and networking
    ... CPU and includes 1 meg of ram and one serial port for terminal I/O The ... GIDE board has two IDE ports called Primary and Secondary which allow ... It is a ATX type motherboard that these ... and another IDE interface. ...
    (comp.os.cpm)
  • 5.3-RELEASE: SMP: system clock has died
    ... I have an ASUS P2B-DS motherboard with dual P2 400MHz CPU's. ... <Parallel port bus> on ppc0 ... unknown: can't assign resources ...
    (freebsd-stable)
  • Re: VIA IDE controller not detected on RELENG_6
    ... indicates strongly that what you have is an Asus motherboard with an VIA ... your system then the PATA controller should be recognized correctly. ... atapci0: port ... 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xfc00-0xfc0f at device 15.1 on pci0 ...
    (freebsd-stable)
  • fatal trap 12 in kernel mode
    ... motherboard, and i hope that's not my problem. ... can't assign resources (port) ... page fault while in kernel mode ... Automatic reboot in 15 seconds - press a key on the console to abort ...
    (freebsd-questions)