Re: How To Stop Chkdsk

Tech Tip: Click here to run a free scan for Windows Errors and optimize PC performance

Assuming your disk is formatted as NTFS, if you go to a command prompt or
type cmd at the run command and type chkntfs/? you can see the options to
turn off the check at boot time.
Neil
"shaka" <grr8shaka@xxxxxxxxx> wrote in message
news:uZvbVgr%23FHA.3104@xxxxxxxxxxxxxxxxxxxxxxx
> Everytime on startup my machine does a chkdsk on one of the partitions.
> Can this be elimnated? OS is WinXP Sp2. TIA
>
> shaka


.

Relevant Pages

  • Re: xp sp2 disk management problem
    ... drivefrom FAT32 to NTFS, XP Disk ... Try converting it from a Command Prompt: ... NTFS partition, the OP might end up with a thrashed NTFS partition. ...
    (microsoft.public.windowsxp.general)
  • Re: 16 bit subsystem error
    ... (NB: %windir% is typically C:\Windows) ... > don't have disk my machine was preloaded in store. ... In the Open box, type cmd, and then click OK. ... At the command prompt, type the following commands, pressing ENTER after ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: xp sp2 disk management problem
    ... drivefrom FAT32 to NTFS, XP Disk ... Try converting it from a Command Prompt: ... the conversion. ... NTFS partition, the OP might end up with a thrashed NTFS partition. ...
    (microsoft.public.windowsxp.general)
  • Re: Startup disk check
    ... If you are sure the disk is OK, then you can turn off the check (assuming ... you are using NTFS) Open a command prompt and type chkntfs/? ... It says it's checking for file system consistency, ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: Hard-drive Recovery - OS Not recognizing previous NTFS formated dr
    ... To convert a volume to NTFS from the command prompt ... Open the Command Prompt window. ... first format the drive to NTFS. ...
    (microsoft.public.windowsxp.hardware)