How do I find out the results of chkdks/ if/where are the bad spots on my harddrive

I got a message from MS saying that I had problems with my HD. Used
properties/tools and had it do a through chkdsk on reboot. Went to bed
as this takes quite some time. Got up and Windows is running but I
have no Idea if any bad spot were found, where is this VERY important
info, what less than intelligent thing did MS do this time to make
this hard to find. Scandisk used to make this easy to find. This is an
XP home system

Thanks

Ralph Malph
.

Relevant Pages

  • Re: How do I find out the results of chkdks/ if/where are the bad spots on my harddrive
    ... | properties/tools and had it do a through chkdsk on reboot. ... CHKDSK results are reported in the "application" section of Event Viewer as ...
    (microsoft.public.windowsxp.hardware)
  • Re: Defrag will not work
    ... are you saying that you did let chkdsk run on reboot? ... you should be able to go to the website of your harddrives mfg and download ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: Cant empty Recycle Bin
    ... I ran chkdsk with /f and later /r each time no problems were found. ... problem clears every time I reboot but this lasts only a short time. ... In My Computer or Windows Explorer, right-click the volume you want to ... the disk checking for the next time you restart your computer. ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: Check Disk
    ... required chkdsk on that partition on each reboot. ... I ran the 'Enable Check Disk Upon Boot' to re-enable auto ...
    (microsoft.public.windowsxp.perform_maintain)
  • Re: CHKDSK Wont Run
    ... Start | Run | MSconfig Put a tick in Diagnostic startup, ... After rebooting try a chkdsk c: ... My defrag won't run until I can get chkfsk or NDD ...
    (microsoft.public.windowsxp.general)