Re: CORRUPTED HARD DRIVE

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance



You can run a windows command from a command prompt to turn off the check.
The drive has been flagged as "dirty" by the system at some time, it may be
failing or it may be stuck in a rut. The command is ran as follows:
1. using the "run" command from the start menu, type "cmd" (no quotes)
2. in the black command prompt window type "chkntfs /x" (no quotes)

you need to be aware this just turns off the boot time check and if the disk
is faulty it will still fail in the future so be sure to check it with the
manufacturers utility.

Neil

"Beaujolais" <Beaujolais@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:5CA22DD6-17EF-4697-B1D4-A8479A712696@xxxxxxxxxxxxxxxx
> My computer (running Windows XP Home Edition) boots up okay but before
> boot-up is complete I get a message saying "Checking file system on C: the
> type of the file system is NTFS, Folume Label is HDD. One of your disks
> needs to be checked for consistency....etc."
> The checking sytem goes through its paces, telling me when each stage is
> completed, then says to wait while computer restarts. (The results don't
> indicate what is actually wrong, if anything, with the file system on C:).
> When computer reboots, the same message pops up and the whole checking
> process restarts, unless I stand by my computer and click out of the disk
> check in the 10 seconds it gives me to do this.
> I've notices that this problem is also preventing me from defragmenting my
> hard drive, so I guess the problems are related.
> I've tried checked the boxes for "Automatically fix file system errors"
> and
> "Scan for and attempt recovery of bad files" when doing a disk check,
> tried
> doing the check in Safe Mode, tried Sytstem Restore (but can't get
> computer
> to restore to any of the 7 dates I've tired, despite the fact they're
> bolded
> as Restore Dates) and tried "Last known Configuration"- all to no avail.
> Full system scan reveals NO viruses/adware or spys ware.
> Any other suggetsions please.
>
> Thanks for anybody's wisdom
>
>
>


.



Relevant Pages

  • Re: partition naming - newbie
    ... hardware address that is assigned to each disk, tape, or CD-ROM. ... Using the prtconf command ... In addition to managing these directories, the devfsadm command also ... Berkeley fast file system. ...
    (comp.unix.solaris)
  • Re: [SLE] Disk full
    ... It seems like all my deleted files are still there and I am unable ... There is a command line utility called du. ... utility to determine why your disk is full. ... is your /home directory a mounted file system or is it part of the ...
    (SuSE)
  • Re: Is there way to get filename for specific LBA?
    ... That does have a 'findblk' command to find a file ... Recently I had a similar problem with a disk (500GB SATA, ... the file system couldn't be marked clean. ... that can give good information about files and inodes. ...
    (freebsd-questions)
  • Re: [SLE] Disk full
    ... remove the files with the rm command and rm -r for folders. ... > utility to determine why your disk is full. ... is your /home directory a mounted file system or is it part of the ...
    (SuSE)
  • Re: New HDD Installation
    ... "John John" wrote: ... a single partition disk. ... confirm or change the active flag of the partition using the FDISK command. ... There are other ways to mark the partition active, either with a Windows ...
    (microsoft.public.windowsxp.general)