Re: ATI Video Card problem.

I find it hard to believe there is no option in the BIOS to disable the
onboard video.

But, you rerally should be asking the tech support folks at Asus for help -
it is their motherboard.

"Anibal" <nospam@xxxxxxxxxxxxx> wrote in message
news:ei$PFaviFHA.1204@xxxxxxxxxxxxxxxxxxxxxxx
> Hi,
> I have problems installing an ATI Radeon 9600 Pro 256 Mbs video card.
> The problem is that the monitor stays allways in stand by mode and it
> doesn't start even if i try to turn it on manually, if i do that, it come
> back to stand by mode.
> I have to take out the card from the AGP slot and conect the monitor to
> the
> integrated video (ATI 9200) conector in order to make it work.
>
> I check in thye bios config utillity and in the MB manual and there is no
> config to disable the on-board video.
> The Radeon 9600 card is well installed fisically and functioning, the fun
> works as i turn on the computer and as i said, when i conect the monitor
> to
> its conector, the monitor correctly enters in stand by mode (the problem
> is
> that it stays in that mode after starting the computer).
>
> My MotherBoard: "Asus P4R800-VM"
> My Bios: "AMI Bios" updated with the last update.
>
>
>


.

Relevant Pages

  • Re: Boot Up issue--sign of infection?
    ... If your system has an actual video board, ... The cable that runs between your monitor and the computer could be ... The first thing I thought of was CMOS battery. ... Three notes regarding your bios in passing: ...
    (microsoft.public.security.virus)
  • ATI Video Card problem.
    ... I have problems installing an ATI Radeon 9600 Pro 256 Mbs video card. ... I have to take out the card from the AGP slot and conect the monitor to the ...
    (microsoft.public.windowsxp.hardware)
  • Re: Display goes bad, seemingly randomly, during install of FC3
    ... Her video card and monitor seem to get properly detected. ... go thru the BIOS to make sure you have PLUG&PLAY set to yes since ... and turn off stuff she'll never use like serial ports, parallel ports, ...
    (Fedora)
  • Re: Display goes bad, seemingly randomly, during install of FC3
    ... >> I'm currently talking my friend through and FC3 install over the ... Her video card and monitor seem to get properly detected. ... go thru the BIOS to make sure you have PLUG&PLAY set to yes ...
    (Fedora)
  • Re: Need to reset BIOS to original settings - without seeing it
    ... How can I reset the BIOS settings to defaults so I can plug the monitor cable into the integrated intel video card and get some video feedback? ...
    (microsoft.public.windowsxp.video)