Re: Need cable info for Micro Solutions model 164550
- From: "labatyd" <mail@xxxxxxxxxxx>
- Date: Sun, 24 Apr 2005 21:51:26 -0600
"Sunny" <sunny@xxxxxxxxxx> wrote in message
news:REYae.667$BW6.199838@xxxxxxxxxxxxxxxxxxxxxxxx
>
>
> labatyd wrote:
>
>> "Sunny" <sunny@xxxxxxxxxx> wrote in message
>> news:9tTae.1323$gA5.84466@xxxxxxxxxxxxxxxxxxxxxxxx
>>
>>>
>>>labatyd wrote:
>>>
>>>>As the subject says, I'm in need of cables for these units (four). What
>>>>are
>>>>the pinouts for such a cable? Are there crossed wires similar to a nul
>>>>modem
>>>>cable or are both ends standard printer connections? Could a person not
>>>>make
>>>>his own? I have sufficient parts on hand for such a project.
>>>>
>>>>Thanks
>>>
>>>All Backpack drives use standard DB25 parallel printer cabling. Any good
>>>quality printer cable will work. Source:
>>>
>>>http://www.micro-solutions.com/support/more_tips/moretips1.asp
>>>
>>>Sunny
>>
>>
>> My next question. Could these backpacks be used with a hard drive as
>> well. I notice there are some wires cutoff on the ribbon cable between
>> the board and drive. Apparantly a CDrom doesn't need as many conductors
>> as a HD. This cable would have to be replaced I expect.
>>
>> Thanks
>
> You want to install a hard drive in a Backpack CD-ROM enclosure?
>
> I think it will probably work, but I'd try it with the existing ribbon
> cable first because the cutoff wires are likely for master/slave selection
> (i.e. not applicable) and/or printer pass-through. You are
Makes sense.
> unlikely to damage anything, even if it doesn't work - but you will be
> experimenting in unknown territory, so don't blame me if something nasty
> happens ;-)
>
Not to worry. I've a number of old smaller HD's around. No great loss.
> A more cautious approach might be to obtain a Backpack hard drive
> enclosure first, so you can see if it uses the same internal wiring as the
> CD-ROM version.
If I could find one to look at.
>
> Sunny
.
- References:
- Need cable info for Micro Solutions model 164550
- From: labatyd
- Re: Need cable info for Micro Solutions model 164550
- From: Sunny
- Re: Need cable info for Micro Solutions model 164550
- From: labatyd
- Re: Need cable info for Micro Solutions model 164550
- From: Sunny
- Need cable info for Micro Solutions model 164550
- Prev by Date: Re: Maxtor 6Y160P0 wont boot after Ghost attempt
- Next by Date: Re: HP 3400C SCANNER WILL NOT RUN WITH SP2
- Previous by thread: Re: Need cable info for Micro Solutions model 164550
- Next by thread: Using a Seagate tape drive for backup
- Index(es):
Relevant Pages
|