CMD PCI-0649 Ultra DMA IDE Controller

From: Eric (res0p435_at_v-e-r-i-z-i-o-n.net)
Date: 04/03/04 

Date: Sat, 03 Apr 2004 03:18:15 GMT

I put this in my PCI slot. I then turn on my computer but nothing will boot,
windows won't load, nothing happens it just sits there. Upon removal my PC
functions/boots fine.

I found these instructions here
http://12.24.47.40/al/12/106/10052.htm

but the problem is my Windows XP came preinstalled, so I don't have an XP
installation CD.

Am I SOL? Is there any way I can get this installed? I could really use the
extra IDE ports.

Eric

Relevant Pages

  • Re: How to grt rid of dual boot XP??
    ... Win2K to an existing WinXP installation; in my experience, ... The computer probably would not boot until the error is corrected. ... Microsoft Windows MVP ... "Ron Sommer" wrote in message ...
    (microsoft.public.windowsxp.general)
  • Re: Winntsys32configsystemCED Error
    ... First thing to do is to boot the computer and see if you can launch the Recovery Console and access the Windows 2000 installation. ... If, on the other hand, you are sure that you are properly logged on to the Windows installation and can't rename, copy between folder or delete files and are getting error messages, or if the "fixed" installation doesn't want to boot, chances are that there is corruption on the disk and you will have to do the chkdsk to try to overcome the problem. ... One thing that still hangs in my mind that you touched on was running ckkdsk /r, since Dell could not do anything with it, was to run this as the first option rather than the latter. ...
    (microsoft.public.win2000.general)
  • Re: memory reading and writing
    ... And, of course, during the boot process, it's mostly ... Plus, remember that Windows uses "on demand" loading...hence, an ... This conspires to mean that once initialisation is run (which is ... "avoiding" to load things until strictly necessary... ...
    (alt.lang.asm)
  • Re: Entry point not found
    ... Open Explorer, go to Tools and Folder Options, on the view tab, scroll to ... I have a brand new hard drive so I'm> thinking of just installing it, re-loading Windows from> scratch and then hook up my old drive as a slave ... As>>far as I can tell, the only way around this would be to> try a clean install>>which entails wiping the drive of all information> currently on it and>>proceeding with setup, this can be done from XP setup as> follows and as>>noted, this will cause you to lose everything on the> partition to which you>>are trying to install XP:>>Assuming your system is set to boot from the CD-ROM> drive, boot with the XP>>CD in the drive. ... >>To Repair a Windows XP Installation using Recovery> Console press R.>>To Quit setup without installing Windows XP, ...
    (microsoft.public.windowsxp.accessibility)
  • Re: Windows XP Home stalls during boot
    ... Assuming your system is set to boot from the CD-ROM drive, ... A few screens into the boot process, if you see the message on the boot ... To Setup Windows XP now, ... To Repair a Windows XP Installation using Recovery Console press R. ...
    (microsoft.public.windowsxp.accessibility)