Re: Ali 8-port FireWire/USB 2.0 PCI: poor performance common?

Tech-Archive recommends: Speed Up your PC by fixing your registry

From: JEM (anonymous_at_discussions.microsoft.com)
Date: 03/04/04 

Date: Wed, 3 Mar 2004 16:21:31 -0800

for USB 2.0 to work you have to have XP SP1 installed, or
use the driver disk that came with the card. If the
drivers are installed correctly, the USB will show up
as 'enhanced USB controller'.

>-----Original Message-----
>"JEM" <anonymous@discussions.microsoft.com> wrote in
message news:<4fbd01c40004$976c1a90$a001280a@phx.gbl>...
>> Try putting in a different PCI slot if it's available.
>> Sounds like IQR sharing issue.... Had the same
problems
>> with ATA controllers, firewire, TV tuners... Usually
the
>> case. Check the MB manual, WEB site, or forum for your
>> board.
>
>Well, swapping the board around did get the Firewire
working properly,
>but the USB 2.0 still acts like 1.1. Although, due to
my case's slot
>openings not being generous enough, I can't plug into
the card's ports
>and have to use the USB 2.0 / Firewire hub I installed
in a 5-1/4" slot.
>Maybe there's something wrong with that, so when the
small hub I need to
>split the one internal USB port shows up, I'll test my
USB 2.0 hard disk
>on the internal port and see if it's any better. I
bought a CompUSA
>8-in-1 media reader for a 3-1/2" slot, and can't run
that and the external
>hub without even more hardware.
>
>Thanks...
>.
>

Relevant Pages

  • Re: Vista USB Printer install issue
    ... where it was asking for the driver disk. ... plugged in the printer again and this time it says USB ... control panel and install from there. ... autodetect a usb printer from the printers control panel. ...
    (microsoft.public.windows.vista.hardware_devices)
  • Re: Barcode
    ... If barcode scanner connected by port keyboard, ... > Must I have component that can access USB? ... Your barcode reader should have a driver disk and some programming ...
    (borland.public.delphi.thirdpartytools.general)
  • Re: erroneous hardware detection
    ... epcific to startup? ... I am assuming the printer is USB. ... different USB port than the one it was on when ... If you do that however...be sure you still have the driver disk for the ...
    (microsoft.public.windowsxp.hardware)
  • usb_insert_transfer panic with if_zyd
    ... When I use my ZyXEL G-220 Wireless USB Stick with the if_zyd driver, ... <ACPI PCI bus> on pcib0 ... device problem, disabling port 1 ... <Ethernet over FireWire> on firewire0 ...
    (freebsd-current)
  • 2.6.10-rc1 & ahci & IHC6R & 925X & raid1
    ... usb modules for console, usb keyboard, network and starting a shell. ... ACPI: PM-Timer IO Port: 0x808 ... PCI: PCI BIOS revision 2.10 entry at 0xfb768, ... usbcore: registered new driver hub ...
    (Linux-Kernel)