Re: Wireless Zero Config service keeps stopping

Tech-Archive recommends: Fix windows errors by optimizing your registry



"smlunatick" wrote:

On Jun 20, 7:27 pm, Will Pittenger
<see.my....@xxxxxxxxxxxxxxxxxxxxxxx> wrote:
There isn't a service listed under Linksys.
-----
will 68 at mtco dot com
will dot pittenger1 at gmail dot com (use this address for large signatures)

smlunatick wrote:
On Jun 20, 1:34 pm, Will Pittenger
<see.my....@xxxxxxxxxxxxxxxxxxxxxxx> wrote:
Not really. I get no error messages at all other than View Available
Networks complaining that the service isn't running. Linksys did
install its own manager, but I disabled it.
-----
will 68 at mtco dot com
will dot pittenger1 at gmail dot com (use this address for large signatures)

Elmo wrote:
Will Pittenger wrote:
Why didn't I get a response?
-----
will 68 at mtco dot com
will dot pittenger1 at gmail dot com (use this address for large
signatures)
Will Pittenger wrote:
I don't know why. But when it does, it takes me a while to figure out
that's what happened, restart it, and reconnect to the network. Today
when it happened, I had to reboot. The service restarted just fine.
But I still couldn't connect to the network.
-----
will 68 at mtco dot com
will dot pittenger1 at gmail dot com (use this address for large
signatures)
Maybe this will help:
http://support.microsoft.com/KB/871122

I know for certain that is other WLAN adapter manufacturer's wireless
network configuration manager software do get a shortcut installed
into the "Startup" folder. Once these softwares start up, the WZC
service gets turned off, even though the service is set to
automatically start.

You may need ti set the Linksys Management console service to "manual"
and re-start WZC service.

I have a Linksys USB wireless adapter and it installs the following
service:

"C:\Program Files\Linksys\WUSB300N\WLService.exe" "WUSB300N.exe"

Not sure if it is the same across the entire line of wireless adapters.

.

Relevant Pages