Re: Windows will not boot up after power outtage.
- From: "shareyourknowledge@xxxxxxxxxxx" <shareyourknowledge@xxxxxxxxxxx>
- Date: Fri, 13 Feb 2009 07:27:32 -0800 (PST)
On Feb 11, 5:04 pm, Andy <1...@xxx> wrote:
On Wed, 11 Feb 2009 10:23:59 -0800 (PST),
"shareyourknowle...@xxxxxxxxxxx" <shareyourknowle...@xxxxxxxxxxx>
wrote:
Thanks for you reply. Yes, it is Maxtor. Here is what happens if i
don't select tab, F8, then Maxtor. I get a prompt that says,"No hard
drive attached to fast track controller. BIOS is not installed". The
next prompt says, NTLDR i missing. Press CTRL+ALT= DEL to install.
That's it.
You have to go into BIOS setup and set the Maxtor drive as the boot
device.
I went into BIOS set up and selected Maxtor as the boot device. I
noticed everything was enabled, except for 32 bit data x-fer. Should i
enable that? Also, i noticed the primary IDE slave and third slave are
not detected. I got another prompt stating that CMOS Checkum is not
installed. Not sure what that is. Thanks again for your help. I am
explaining as best i can with the limited computer knowledge that it
have.
.
- References:
- Windows will not boot up after power outtage.
- From: shareyourknowledge@xxxxxxxxxxx
- Re: Windows will not boot up after power outtage.
- From: Patrick Keenan
- Re: Windows will not boot up after power outtage.
- From: shareyourknowledge@xxxxxxxxxxx
- Windows will not boot up after power outtage.
- Prev by Date: Re: system restore
- Next by Date: Display problems on re-installing XP
- Previous by thread: Re: Windows will not boot up after power outtage.
- Next by thread: Re: Windows will not boot up after power outtage.
- Index(es):
Relevant Pages
|
