I recently replaced the motherboard for this computer and reinstalled xp from
the facotory disk. I started having powerdown issues, so I did another boot
to factory to locate which program was causing the problem. Everything worked
fine until I added sp2. Since that install, the computer gets to the shutting
down screen and from there, has to be manually turned off. What do I need to
check to clear up this problem?
.
Re: Windows not starting/booting sometimes? ... I have seen this exact condition whenever there is a primary partition on more than one hard drive and both of the primary partitions have the boot flag set.... and do a factory restore later on. ... wait 5 or 10 minutes, then the screens says "fail to boot disk, please ... (microsoft.public.windows.vista.general)
Re: Please help ... Different systems require different ways to entering the BIOS,... You can put your XP cd in and then restart your computer most factory... systems are set to boot the ROM drive before the harddrive, ... When doing a repair install it is always a good idea to backup all important ... (microsoft.public.windowsxp.general)
Re: windows xp boot up from flash ... I have never seen "restore to factory defaults" available in the F8 menu. ... Mark L. Ferguson...bootup program available to get it to boot from flash? ... (microsoft.public.windowsxp.help_and_support)
Re: Itanium hardware Q ... I you are starting off from an IA64, fresh out of the factory, still in its birthday suit and virgin disk drive, would it be able to boot from a USB DVD drive containing the VMS installation kit?... (comp.os.vms)
reset rx2600 ... Is there a way to reset the rx2600 to factory defaults??? ... I tried to boot up the install that said it was faulted (see prior post) ... (comp.os.vms)
