USB2.0 not recognised
I have an ASUS motherboard (P5S800-VM-UAYGZ) which has a number of USB2.0
ports. When I plug a USB2.0 device in, I get a "this device can perform
faster . . " message. If I click on the message I get "HI-SPEED Device
attached to non-HI_SPEED Hub" message with the recommendataion "You mst add
a HI_SPEED USB host controller to this computer to obtain maximum
performance".
As far as I can remember I installed the default drivers on the installation
disk when I installed this motherboard.
Is there a driver problem and how can I remedy this?
--
.
Relevant Pages
- Re: Power Supply
... Did you plug all the cables back they way they were when the old power supply ... Since this is a Asus motherboard, do not connect the EZ Plug at the same time ... "Hardware monitor found an error. ... something like CPU frequency at shutdown was wrong, ...
(microsoft.public.windowsxp.general) - Re: upgrade from XP Home to XP Pro. installation problem
... BAD_POOL_CALLER usually is indicitive of a driver problem. ... piece of hardware in the system that is not natively supported in a retail ... Associate Expert - WindowsXP Expert Zone ... > When I attempt to complete the installation of XP ...
(microsoft.public.windowsxp.newusers) - Re: Power Supply
... I'm not even sure what EZ plug is. ... Since this is a Asus motherboard, do not connect the EZ Plug at the same ... "Hardware monitor found an error. ... something like CPU frequency at shutdown was wrong, ...
(microsoft.public.windowsxp.general) - USB External Hard Drive
... OneTouch USB Hard Drive. ... the installation of the image and it tries to run the ... First Boot Agent I get a blue screen error "Stop ... At first I thought this was a driver problem however when ...
(microsoft.public.windowsxp.embedded) - Re: to XP64 or not
... |> Pip wrote: ... |>> causing this as the installation trips over at the last moment (as ... you would dive into new driver probs! ...
(alt.comp.hardware.pc-homebuilt) |
|
