Re: Can't Start Windows In Safe Boot




"Craigie" <Craigie@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:9345F354-FB4E-4569-BFC7-92F88858A4CE@xxxxxxxxxxxxxxxx
Hi gang,

My PC was acting all wierd, so I decided to run Ewido in safe boot mode.
Problem I am having now is that it will not boot at all now as the
following
screen comes up "Windows could not start because the following file is
missing or corrupt : system32\DRIVERS\pci.sys

You can attempt to repair this file by starting Windows setup using the
original Setup CD-Rom
Select 'r' at the first screen to start repair"

I stuck in the CD and nothing happens, is this because I am in safe boot?
Anyone help please?
I made a back up of all my stuff before I tried the safe boot anyway so
even
if i lose it all it does not matter......

I hold down F8 while booting but it keeps taking me to the above error
page
no matter what option I choose.

Thanks for any help

I have XP pro service pack 2

This is a refreshing change of tune. Most posters in your
situation squeal because they have irreplaceable files which
they did not think of backing up until disaster struck.
Well done!

To start the repair process, you have to instruct the BIOS
to use the CD drive as the primary boot device. Reboot
the PC, then press the key that gets you into the BIOS
setup. It is often the Delete key. Sometimes there is a
message on the screen that tells you how to get into the
BIOS or what key to press to change the boot order. If
you cannot see it, read the manual that came with your PC.

After the PC boots from the WinXP CD, follow the prompts.


.



Relevant Pages

  • Re: Installing xp on new hard drive
    ... but not how to boot from the new one. ... least do a repair install - with the new HD in place as the primary master. ... then press F6 early in the Setup process to install those drivers. ... BIOS to boot from CD and then you boot with the WinXP CD-ROM in the drive, ...
    (microsoft.public.windowsxp.basics)
  • Re: Installing xp on new hard drive
    ... I will try and boot from cd first then when I get out of the blue screen ... change the bios option to load from the hard drive. ... > least do a repair install - with the new HD in place as the primary master. ... > then press F6 early in the Setup process to install those drivers. ...
    (microsoft.public.windowsxp.basics)
  • RE: dual boot & bios
    ... I flashed my bios to the new file, ran the recovery console "map" it found ... record and I was taken back to the selection screen on boot. ... Setup went without a glitch formated the partition fat32, ...
    (microsoft.public.win2000.file_system)
  • Re: NO ROM BASIC, System halted
    ... You can actually stop it from doing the ScanDisk on Boot Up (if you ... was that Message from the *BIOS* then? ... & which "SETUP" is it referring to? ... tried to Boot from the HDD (Hard Disk Drive) & couldn't & the Floppy ...
    (uk.people.silversurfers)
  • Re: BIOS SETTINGS
    ... You boot your system, and BEFORE Windows starts to load, you press the key that YOUR brand ... you boot tells you which key to press to enter Setup (BIOS). ... navigate until you see the settings for the boot sequence ...
    (microsoft.public.windowsxp.general)