Re: PRIMARY HARD DRIVE RUMBLE



Look in the bios, if the motherboard has a speed fan control the bios normally(look under power options main or a submenu) also would contain settings to autodetect/enable/disable monitoring for cpu temperature, motherboard temperature, and fan speed settings. Fan speed settings may also have an option to vary the fan speed as a function of full speed based on a hardware characteristics.
Some OEM supplied motherboards even though similar in brand to retail mobos do not have this feature(excluded or wires not connected etc).

..winston

"Sam" <samnewsgrp71@REMOVE THISsbcglobal.net> wrote in message news:dtMxh.7944$O02.2156@xxxxxxxxxxxxxxxxxxxxxxxxxxxxx
: Thanks very much for your reply. I should have noted that I periodically
: run the HD Tune program and so far, have not seen any problems with the
: primary or secondary HDs. As to the recommended Speed Fan program, not long
: ago I read somewhere on the internet that older Dell mother boards would not
: provide such values as temperatures, etc.. However, I will go ahead and
: install the Speed Fan program and see what it provides. I should note that
: weekly I am accomplishing a full primary partition image backup and critical
: data files backup as well. Thanks again, Sam.
:
:
: "R. McCarty" <PcEngWork-NoSpam_@xxxxxxxxxxxxxx> wrote in message
: news:eFamG6VSHHA.2228@xxxxxxxxxxxxxxxxxxxxxxx
: > Drives require a "Firm/Tight" mounting in the cage or bracket. Most
: > modern drives are very quiet and don't have much in the way access
: > noise. Many drives offer Acoustical settings ( a trade off between
: > speed and noise ) but the option varies depending on which vendor
: > drive you have.
: > All that being said any "Noticeable" noise from a hard drive is cause
: > for concern. You probably should get a tool that will allow you to
: > check the SMART statistics on the drive. Speed Fan 4.31 will show
: > you this information if your motherboard/drive supports it.
: > http://www.almico.com/sfdownload.php
:
:
.



Relevant Pages

  • Re: PRIMARY HARD DRIVE RUMBLE
    ... ahead and install the Speed Fan program and see what it provides. ... Many drives offer Acoustical settings (a trade off between ... speed and noise) but the option varies depending on which vendor ...
    (microsoft.public.windowsxp.general)
  • Re: PRIMARY HARD DRIVE RUMBLE
    ... install the Speed Fan program and see what it provides. ... Many drives offer Acoustical settings (a trade off between ... speed and noise) but the option varies depending on which vendor ...
    (microsoft.public.windowsxp.general)
  • VIA 8253 UDMA ICRC errors
    ... >Does anyone else have a problem lately with VIA-based motherboards and relatively ... any combination of the following gives me a load of UDMA ICRC ... >I have tried using two different 160G hard drives from two different vendors ... >from CD causes an immediate error, installing from ftp at about 300 Kbytes/sec ...
    (freebsd-current)
  • Re: Why I Dont Use Computers for Audio Very Much
    ... cases, power supplies, motherboards, etc. which make ... time to open up the machines and swap drives around than it does to ... that environment, ... I should point out that I haven't had wide experience with recent Dell ...
    (rec.audio.pro)
  • Re: VIA 8235 UDMA ICRC errors
    ... Check cable connections, replace the cables, download and use ... I've tried replacing pretty much everything, including power supplies, drives ... Thank you for your advice, and the same goes to Doug White. ... >> broken, bad hardware (but it works with other motherboards), something that is ...
    (freebsd-current)