Re: menu speed

Try with a different profile. Sounds like the one you are using is not writing changes out to disk.

Dan wrote:

thank you for your reply.

I tried the .reg file and it didn't work.

Thanks again.



"LFR" wrote:


try this:


http://www.kellys-korner-xp.com/regs_edits/menudelay.reg

"Dan" wrote:


Hello folks,

The menu speed on my laptop keeps defaulting to 0 when I boot. I have installed TweakUI and it works for that session, but when I reboot, its back to hyper speed.

I've gone into the registry and manually set the delay time to 400 (it shows 0) and, again, it works until I reboot again............

Any ideas or suggestions.

Thanks......................

.

Relevant Pages

  • Re: device packages?!?
    ... i'll be back on here in a couple hours, but dan, if youre gone by ... 'cause AIX still isnt recognizing them, ... original WARNING msg's from my first post. ... ibm's fixcentral, burned them to disk and tried it with that disk, but ...
    (comp.unix.aix)
  • Re: Disk Geometry
    ... Dan Simmonds wrote: ... > up my hard drive and I've forgotten what the disk looks like. ... > commands I seem to have available are mount commands. ... you will want to fsck and attempt to ...
    (freebsd-questions)
  • Re: TCP parameters and interpreting tcpdump output
    ... Dan> A shrinking window and no packet loss is an indication that the program ... Dan> the socket is connected to isn't reading data fast enough. ... Dan> perceived packet loss, are troubling. ... I can write to the disk at approx 6 M Bytes/sec ...
    (freebsd-questions)
  • [HPADM] Re: SUMMARY question about disks
    ... helpful responses. ... Dan Zucker ... it boot again. ... I had a disk setup via LVM that was the boot disk for one machine I had. ...
    (HP-UX-Admin)
  • Re: Invalid system disk
    ... Dan the K schrieb: ... >> "Invalid system disk ... >> Replace the disk, ... no bootable FAT partition on the disk? ...
    (comp.sys.ibm.ps2.hardware)