Re: UNMOUNTABLE_BOOT_VOLUME

I appreciate that you are responding to my post. If you read what I wrote
however, you will notice that I said I made floppies from the CD and not that
I tried to use the CD for the drivers. I am well aware that XP setup will
not take drivers from anywhere except a floppy disk at this time.

I have since been in the BIOS and disabled everything that was not
absolutely necessary to run the computer. (IE: hyperthreading, USB, onboard
network, RAID) I am still getting the stop error. It has changed slightly
though. now the technical information reads:
STOP: 0x000000ED (0x8239f7d8,0xc000010,0x00000000,0x00000000)

Not sure if this will help any, but I hope so as this is getting extremely
annoying.



"Rick "Nutcase" Rogers" wrote:

Hi,

XP setup will not recogniz SCSI/RAID drivers on anything but a floppy -
something several of us have been fighting with MS about for a number of
years. This may be changed with Vista, but that's not going to help you
right now.

--
Best of Luck,

Rick Rogers, aka "Nutcase" - Microsoft MVP
http://mvp.support.microsoft.com/
Windows help - www.rickrogers.org

"Grommley" <Grommley@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:7E99269D-EC1D-4AD7-8900-8FDDFA6C5112@xxxxxxxxxxxxxxxx
I never enable BIOS level virus protection. I re-install too often for
that.
However, I did go check to verify that it was off in this case as well.
BIOS level virus protection is disabled. I have also been checking
through
responses to others that had the same question. A lot of the answers
involve
booting to the CD and running recovery console to do a CHKDSK. I cannot
even
get it to boot to the Welcome to setup screen from the CD in order to
choose
the recovery console. I can press F6 to install SCSI/RAID drivers, and if
I
try this (which is supported by my motherboard, but not in use) it just
keeps
asking my for the floppy with the drivers on it. It will not recognize
the
floppy that came with the mainboard, or any of the ones I made from the CD
(instructions were provided on the CD). It never gets any further than
this
either. Just past this is the point at which I get the error. Nothing
more
I can do. This is kinda frustrating on a 6 month old computer.

Anything anyone could tell me that I could try would be appreciated.

"Rick "Nutcase" Rogers" wrote:

Hi,

Check the BIOS for antivirus detection settings and disable them. They
preclude setup from writing to the mbr which it normally does during
setup.
Once installed, it can be reenabled.

--
Best of Luck,

Rick Rogers, aka "Nutcase" - Microsoft MVP
http://mvp.support.microsoft.com/
Windows help - www.rickrogers.org

"Grommley" <Grommley@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:48E5DA1B-5C8E-4F27-B97C-C6D2C2F7A613@xxxxxxxxxxxxxxxx
I am getting this error when I try to re-install Windows. I can boot to
the
existing copy of Windows just fine. I would like to format and
re-install
or
install to a different hard drive (both options are available to me).
The
technical information displayed is:
stop: 0x000000ed (0x822ed9f0,0xc0000010,0x00000000,0x00000000)

There have been no hardware changes made (except when I tried a
different
hard drive). I am using an 80 wire IDE cable. If more information
would
be
helpful, I can give a complete list of the hardware I am using.

Any help would be appreciated.






.

Relevant Pages

  • Re: UNMOUNTABLE_BOOT_VOLUME
    ... I have replaced the floppy drive, ... Windows help - www.rickrogers.org ... I tried to use the CD for the drivers. ... I am well aware that XP setup will ...
    (microsoft.public.windowsxp.general)
  • Re: XP Setup doesnt see SATA drive... and more
    ... I am trying to go through Windows XP Pro setup (the 6 floppy disk setup from ... basically asks me to put the floppy in that has my drivers. ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: Installing xp on new hard drive.
    ... >> how to install drivers from a floppy diskette. ... >> running Setup. ...
    (microsoft.public.windowsxp.newusers)
  • Re: Crashed computer
    ... > setup asks if I need to load any other drivers, (I hit enter to skip since ... > I wasn't sent any floppy at all) then after looking like it's going to ... be directed if that's who you bought WinXP from. ...
    (microsoft.public.windowsxp.hardware)
  • Re: WINLOGON.EXE
    ... purchase it from someone else as most manufacturer's setup the system to ... >>>download using that as this is a rather large download. ... >>>you install updated drivers, ignore the message about ... >>>System Restore in case you have problems as a result of ...
    (microsoft.public.windowsxp.general)