Re: Microphone Problems!

Tech-Archive recommends: Repair Windows Errors & Optimize Windows Performance



In that case I feel I cannot help. But
Have you tried the Master Vol control - double click on the little speaker
icon in the task bar bottom right. This should show the Mast Vol - Click on
Options - then Props and you should then have a choice of Input and Output.
Each one chosen then gives a list of vol controls you want to show in the
Mast Vol. Make sure Mic or coloured jack are ticked and that they are not
muted in the Mast Vol.
In my case the headset goes into front pink and green as choice - they could
go in the rear also.
Sorry I cant help further than this.
Have you contacted the computer builder for help?
With my mic, and I cannot explain why, I have to wait up to 30 seconds
before it works i.e. on testing I hear my voice in my speakers.
Rgds
Antioch


"Emily" <Emily@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:9E6BE264-87D4-403F-AC66-654CD7396213@xxxxxxxxxxxxxxxx
the audio manager is sigma tel audio, the one that came with the computer.
and the headset isn't anything too special, just like a $15 combination
thing, the brand is NGS. thanks!

"antioch" wrote:

I had exact same problem, but what make is your Audio Manager and
headset?
Might be able to help.
Antioch


"Emily" <Emily@xxxxxxxxxxxxxxxxxxxxxxxxx> wrote in message
news:2F91B949-C93F-41F6-92C8-D39AA7D942C0@xxxxxxxxxxxxxxxx
I can't get my computer to be able to recognize a microphone. I have a
headset with the two different plugs for headphones and microphone
which
is
plugged in. I installed the speech recognition thing, but the
microphone
still doesn't show up on the main volume control panel on the start
bar.
any
suggestions? when i ran the sound device problem diagnostic test, it
said
everything was working well. i don't know a whole lot about computers,
so
i'm not sure if there's a simple step i am overlooking.





.



Relevant Pages

  • Re: Logitech USB Headset 350 not supported in MCE 2005?
    ... USB headset and reboot your system and do not start MCE and then and plug ... > I know that if just XP MCE would install the driver correctly, Windows ... Your windows volume control may be controling the output ...
    (microsoft.public.windows.mediacenter)
  • Re: How to switch between handset and headset? (TSP designers weigh in)
    ... phoneSetHookSwitch functions. ... lineSetTerminal can be used, amont other things, to route audio ... You can then control MEDIATOLINE and MEDIAFROMLINE to effectively ... Then there is phoneSetHookSwitch that has a HEADSET, ...
    (microsoft.public.win32.programmer.tapi)
  • Re: Motorola E815?
    ... >> I have a question concerning the hardwired car kit. ... >> I've done many car stereos, ... >> wearing the headset for extended periods is a little uncomfortable as ... The kit consists of a control box, microphone, speaker, cable. ...
    (alt.cellular.verizon)
  • Re: Dell Dimension 8300 with Audigy 2 Problems
    ... Sounds like the USB Headset does the same thing since you state that it ... Logitech USB 250 Headset created a second volume control. ...
    (alt.sys.pc-clone.dell)
  • Re: How do I setup a microphone?
    ... just plug in your headset and mic into their respective plugs. ... your volume control when then shift to recording control and you can control ... controlling the volume/recording levels using its interface. ... system tray, and specifically, recording levels as described above. ...
    (microsoft.public.windowsxp.general)